2.5 Setting Pressure Parameters during Initial Start-Up
This part of the display indicates the current pressure, sea level pressure, and moon phase.
A number of historical statistics can also be viewed, such as the sea-level pressure values for the last 24 hours, moon
phase for the previous and next 39 days, as well as a pressure history bar-chart.
Pressure values may be displayed inHg, hPa/mBar or mmHg, and altitude values may be displayed in meters or feet.
Accessing Pressure Mode
From the main console unit: [ ▲ ] or [ ▼ ]until the icon
Setting Pressure Parameters during Initial Start-Up
During the initial start-up of the Main Unit, the pressure settings should be configured in following steps.
1.
Choose Pressure Units:
The unit icon "inHg" or "mmHg" or "hPa/mBar" should be flashing. [ ▲ ] or [ ▼ ] to select pressure unit as inHg,
hPa/mBar or mmHg
Press [ SET ] to confirm your selection.
2.
Choose Altitude Units:
Press [ ▲ ] or [ ▼ ] to select altitude unit as feet or meters.
Press [ SET ] to confirm your selection.
3.
Set Altitude:
[ ▲ ] or [ ▼ ]to adjust value. Press and hold either button for fast advance.
Press [ SET ] to confirm your selection.
4.
Upon completion the display will be returned to Pressure and Weather Forecast Mode.
Note: After initial start-up the altitude cannot be adjusted immediately
Viewing Pressure and Altitude Data
In Pressure Mode, each press of [ SET ] rotates display between:
- Sea level pressure
- Local pressure
- Local altitude
Setting the Sea Level Pressure
1.
In Pressure Mode, press [ SET ] until the sea level pressure is displayed.
2.
Press and hold [ SET ]. The Sea Level Pressure display should be flashing.
3.
Set Sea Level Pressure:
[ ▲ ] or [ ▼ ] to adjust value. Press and hold either button for fast advance.
Weather Station User Guide
Model: VENTUS W928-ULTIMATE
Version 3.0
Date 25.9.2008
starts flashing.
Page 49 of 193