Special Safety Instructions - Probuilder 40555 Gebrauchsanweisung

Special safety instructions

Always secure the item to be worked with
clamps or similar. Never hold the item in
place by hand.
Always use the correct type of disc for the job
at hand.
Never use discs whose maximum speed is
less than the tool's maximum RPM.
Never use discs which are too big.
Never use damaged or worn discs, or discs
that cannot be easily � tted to the angle
grinder spindle. Never use an adapter ring
or similar to � t discs with holes that are too
large.
Never allow the disc to be in contact with the
workpiece or other objects when starting the
angle grinder.
Never place your hand or � ngers near the
disc while the grinder is running.
Keep the handle and the grinder as a whole
free of oil, grease, water and other liquids.
Never depress the spindle lock while the disc
is rotating!
Never put the grinder down until the disc has
completely stopped rotating.
Do not touch the worked item or metal
� lings until they have cooled.
Do not use the angle grinder on items made
of magnesium.
Preparation
Fitting the support grip
Fit the support grip (7) in the thread on the
left or right side or at the top of the angle
grinder, depending on whether it is to be
used by a left- or right-handed person. Check
that the support grip is secure.
Adjusting the protective shield
Loosen the screw (2) but do not unscrew
completely.
Position the protective shield over the angle
grinder and turn it to the required position.
Re-tighten the screw.
The protective shield must be positioned to
protect the user if the grinding disc shatters
during use, causing parts to � y out.
GB
21