Chicco finder Bedienungsanleitung Seite 11

size. There are other straps on the sides of the waist strap
ng for additional adjustments (fig. 5A).
lu- 6. To complete the adjustments, fasten and adjust the chest
strap buckle as well (fig. 6).
WARNING: if any of these adjustments is not done correctly,
NG the backpack may not be stable during use.
PLACING THE CHILD IN THE BACKPACK
ng. 7. The seat features a 5-point safety harness (fig. 7). Pad-
ays ded shoulder straps and a headrest are featured for your
ms. child's comfort.
8. The seat has two protective flaps on the sides (fig. 8).
These feature straps that can be opened and adjusted
using the buckle to adjust the distance between the seat
and the parent's back (fig. 8A).
9. After opening a lateral protective flap and releasing the
harness, put your child in the seat. To fasten him securely,
pass his arms through the two belts/shoulder straps (fig.
9) and fasten them in the buckle located under the seat
(fig. 9A). Using the seat's lateral straps (fig. 9B) you can
adjust the length of the belts. To complete this step, close
the lateral flap that you opened previously (fig. 9C). To
remove the child from the backpack, follow these same
steps in the opposite order.
10. Using the strap on the front of the seat you can adjust it
ng, to your child's height (fig. 10).
11. Once you wear the backpack, you can make it compact
g it by closing the rear tubular bar as shown in figure 11.
ntil
en WARNING: Before removing the backpack, always open the
stand again. Place the backpack on a level surface making
py sure it is stable.
he
ric WARNING: It is necessary to utilise safety harness in order to
guarantee your child's safety.
p- FITTING AND REMOVING THE BACKPACK LINING
12. Fully unzip the zipper at the base of the backpack to
remove the lining (fig. 12); undo the buttons located un-
der the front feet and move the strap forward (fig. 12A).
rst Then, using the two fabric handles located on the top
ou of the backpack, use one hand to pull the lining upward,
ck whilst the other hand keeps the frame steady (fig. 12B).
in 13. To line the backpack, insert the frame inside the spe-
cific fabric slots, making sure that the rear tube is fitted
inside the appropriate fabric pocket (fig. 13) and push
to the structure until it is properly in place. Complete the
ed lining process by positioning the fabric strap under the
all- front feet and clasp the buttons; lastly, pull the zipper
he closed (previously opened) located at the base of the
he backpack.
ole
POCKETS
ck 14. There is an item holder compartment under the child's
dy seat that you can open using the two zippers located on
ey both sides of the backpack (fig. 14).
ect 15. There is a pocket with zipper on the back of the back-
in pack (fig. 15).
hat 16. Both sides of the waist strap feature small openings to
insert small objects (fig. 16).
kle
dy
BABY BIB
17. The backpack has a convenient bib in the upper
part of the parent's backrest. To attach/remove the bib,
use the relevant buttons (fig. 17).
RAIN COVER
18. To attach the rain cover, fit it on the backpack from the
top until it is attached to the canopy. Then run the strip
with the button under the parent's shoulder straps and
fasten it to the relevant hole. To complete installation,
fasten the 2 velcro strips around the front handle and
close them (fig. 18).
WARNING: the rain cover can be used on the backpack only
with the canopy on.
11