Adjusting Source Levels; Initial Settings; Adjusting Initial Settings - Pioneer DEH-1400RB Bedienungsanleitung

Audio Adjustments

Adjusting source levels

SLA (Source level adjustment) lets you adjust
the volume level of each source to prevent radi-
cal changes in volume when switching between
sources.
• Settings are based on the volume level of the
FM tuner, which remains unchanged.
1 Compare the FM tuner volume level with
the level of the source you wish to adjust.
2 Press to select
AUDIO
Press until
AUDIO
3 Press 5 or ∞ to adjust the source volume.
Each press of 5 or ∞ increases or decreases
the source volume.
• –
SLA +4 SLA –4
volume is increased or decreased.
Notes
• Since the FM tuner volume is the control, it is
not possible to apply source level adjustments
to the FM tuner.
• The MW/LW tuner volume level can also be
adjusted with source level adjustments.
15 En
.
SLA
appears in the display.
SLA
is displayed as the source

Initial Settings

Adjusting initial settings

Initial settings lets you perform initial set up of
different settings for this unit.
1 Press and hold until the unit turns
SOURCE
off.
2 Press and hold until
AUDIO
in the display.
Press repeatedly to switch between the
AUDIO
following settings:
—
STEP A-PI
Use the following instructions to operate each
particular setting.
• To cancel initial settings, press
• You can also cancel initial settings by holding
down until the unit turns off.
AUDIO
appears
STEP
.
BAND