Troubleshooting; Technical Data - Clatronic hdm 2985 Bedienungsanleitung

GB
The heating rods are turning but the device is not heating up!
Note! The heating is only switched on by the timer switch. If the device does not
heat up, please check the mains connection and that the timer has been correctly
set.
• Always pull out the plug from the mains socket before cleaning and wait until
the unit has cooled down.
• Do not use any wire brush or other abrasive objects.
• Do not use any acidic or abrasive detergents.
• Under no circumstances should the device be immersed in water for cleaning.
Heating Rods
• Please remove any food residues while they are still warm with a damp cloth or
paper towel.
• Wash off the heating rods with a soft sponge and soapy water, then rinse with
clear water and dry thoroughly with a soft cloth. After drying, apply a thin fi lm
of edible oil to the surface.
Fat Collecting Pan
Pull out of the fat collecting pan. Shake the contents out and clean the drawer in
soapy water.
Housing
Clean the housing after use with a slightly damp cloth.
Model:...................................................................................................... HDM 2985
Power supply: ....................................................................................... 230 V, 50 Hz
Power consumption: ....................................................................................... 300 W
Protection class: ...................................................................................................... Ι
This device has been tested according to all relevant current CE guidelines,
such as electromagnetic compatibility and low voltage directives, and has been
constructed in accordance with the latest safety regulations.
Subject to technical changes without prior notice!
38
05-HDM 2985 38

Troubleshooting

Cleaning

Technical Data

17.08.2005, 8:42:22 Uhr