Manual Settings - Emos E5005 Bedienungsanleitung

Displaying Data from Multiple Sensors, Automatic Cycling through Values from
Connected Sensors
Press the CH button repeatedly to display data from all connected sensors one by one.
You can also activate cycling through data from all connected sensors:
1. Turning on cycle mode
Repeatedly press the CH button until the display shows icon
Data from all connected sensors will be shown automatically and repeatedly one after another.
2. Turning off cycle mode
Repeatedly press the CH button until icon
Radio Controlled Clock (DCF77)
After registering with the wireless sensor, the weather station will automatically begin searching for
DCF77 signal (hereinafter referred to as DCF) for 7 minutes; the icon will be flashing. No other data
on the display will be updated while the search is in progress and all buttons will be disabled (except
for SNOOZE•LIGHT). Once signal is detected, the icon will stop flashing and the current time will be
displayed along with the
the search for DCF signal, hold buttons
again hold buttons MEM and
between 2:00 and 3:00 am.
Note: If the weather station detects DCF signal but the current time on the display is incorrect (e.g. shifted
±1 hour), you must always set the correct time zone for the country where you are using the station, see

Manual Settings.

In standard conditions (at safe distance from sources of interference, such as TV sets, computer mon-
itors), the reception of time signal takes several minutes. If the weather station does not detect the
signal, follow these steps:
1. Move the weather station to another location and try to detect DCF signal again.
2. Check the distance of the clock from sources of interference (computer monitors or television sets).
It should be at least 1.5 to 2 m during the reception of the signal.
3. When receiving DCF signal, do not place the weather station in the proximity of metal doors,
window frames and other metal structures or objects (washing machines, dryers, refrigerators etc.).
4. In reinforced concrete structures (cellars, high-rise buildings etc.), the DCF signal reception is
weaker, depending on the conditions. In extreme cases, place the weather station close to a
window toward the transmitter.
Reception of the DCF 77 radio signal is affected by the following factors:
• thick walls and insulation, basements and cellars
• inadequate local geographical conditions (these are difficult to assess in advance)
• atmospheric disturbances, thunderstorms, electrical appliances with no interference elimination,
television sets and computers located near the DCF receiver.
Manual Settings
1. Long press the MODE button.
2. Then, repeatedly press the MODE button to choose settings for: 12/24 time format – time zone –
date format – year – month – day – hour – minute – calendar language – bar. pressure unit (hPa,
InHg) – °C/°F temperature units.
You can move between the values by pressing the MODE button, set values using buttons
and HISTORY.
Calendar languages are as follows:
EN – English; GE – German; DA – Danish; SP – Spanish; DU – Dutch; FR – French; IT – Italian
Setting Altitude
To achieve more accurate calculation of pressure values, it is advised to manually set the altitude for the
place where the weather station is being used.
1. Hold the SNOOZE•LIGHT button until the altitude value starts flashing.
disappears.
DCF icon. If no signal is detected, the DCF icon will not be shown. To repeat
MEM and
HISTORY simultaneously. DCF signal will be synchronised daily
6
.
HISTORY simultaneously. To cancel the search,
MEM