Manual Settings - Emos E5010 Handbuch

3. Set the desired sensor channel number (1, 2, 3) by repeatedly pressing the CH button located
in the battery compartment of the sensor. The channel number will be shown on the sensor's
display. Data from the sensor will be loaded within 3 minutes.
4. If sensor signal is not detected, remove the batteries and reinsert them.
Displaying Data from Multiple Sensors, Automatic Cycling through Values from Connected
Sensors
Press the CH button repeatedly to display data from all connected sensors one by one. You can also
activate automatic cycling through data from all connected sensors:
1. Turning on cycle mode
Repeatedly press the CH button until the display shows the
Data from all connected sensors will be shown automatically and repeatedly one after another.
2. Turning off cycle mode
Repeatedly press the CH button until the
Radio-Controlled Clock (DCF77)
After being registered by the wireless sensor, the weather station will automatically start searching
for DCF77 signal (DCF for short) for 7 minutes; the
on the display will be updated and buttons will be disabled (except SNOOZE•LIGHT). Once the signal
is found, the icon will stop flashing ( stays on the screen) and current time will be displayed. If no
signal is detected, the DCF icon will not be shown.
To repeat the search for DCF signal, briefly hold the UP and DOWN button at the same time. To cancel
the repeat search, long press the UP and DOWN buttons at the same time again. DCF signal will be
synchronised daily between 2:00 and 3:00 am.
Note: If the weather station detects DCF signal but the current time on the display is incorrect (e.g.
shifted ±1 hour), you must set the correct time zone for the country where you are using the station,
see Manual Settings.
In standard conditions (at safe distance from sources of interference, such as TV sets or computer
monitors), the reception of time signal takes several minutes. If the weather station does not detect
the signal, follow these steps:
1. Move the weather station to another location and try to detect DCF signal again.
2. Check the distance of the device from sources of interference (computer monitors or television
sets). The distance should be at least 1.5 to 2 m during the reception of signal.
3. When receiving DCF signal, do not place the weather station in the proximity of metal doors, win-
dow frames and other metal structures or objects (washing machines, dryers, refrigerators etc.).
4. DCF signal reception is weaker in reinforced concrete structures (cellars, high-rise buildings etc.),
depending on the conditions. In extreme cases, place the weather station close to a window in
the direction of a transmitter.
Reception of DCF77 radio signal is affected by the following factors:
• thick walls and insulation, basements and cellars;
• inadequate local geographical conditions (these are difficult to assess in advance);
• atmospheric disturbances, thunderstorms, electrical appliances with no interference elimination,
television sets and computers located near the DCF receiver.

Manual Settings

1. Long press the MODE button.
2. Then, repeatedly press the MODE button to choose settings for: 12/24 time format – time zone
– date format – year – month – day – hour – minute – calendar language – bar. pressure unit
(hPa, InHg) – °C/°F temperature units. You can move between the values by pressing the MODE
button, set values using UP and DOWN.
Calendar languages are as follows:
GE – German; EN – English; DU – Dutch; DA – Danish; IT – Italian; SP – Spanish; FR – French
Setting Altitude / Weather Forecast Icon
To achieve more accurate calculation of pressure values, it is advised to manually set the altitude
for the location where the weather station is being used.
icon.
icon disappears.
icon flashes. During the search, no other data
5