Weather Forecast - Emos E5005 Bedienungsanleitung

Weather Forecast

The station forecasts weather on the basis of changes in atmospheric pressure for the next 12–24 hours
for an area within the range of 15–20 km.
The accuracy of weather forecast is 70–75 %. The forecast icon is displayed in field no. 11.
As the weather forecast may not be 100 % accurate, neither the manufacturer nor the seller can be held
responsible for any loss caused by an incorrect forecast.
When you first set or reset the weather station, it takes about 12 hours before the weather station
begins forecasting correctly.
Weather Forecast Icons:
sunny cloudy overcast rain heavy rain
– the snowflake icon appears at outdoor temperature between -3 °C to +1 °C.
Nice Environment Icon – Smiley
Nice environment icon is displayed in field no. 30.
If the humidity is between 40–70 % RH and the temperature between 20–28 °C, the screen will show
the COMFORT icon – nice environment.
If the humidity is lower than 40 % RH, the screen will show the DRY icon – dry environment.
If the humidity is higher than 70 % RH, the screen will show the WET icon – wet environment
If temperature is not between 20–28 °C and humidity is not between 40–70 % RH, no icon will be
displayed.
Setting Temperature Limits for Maximum and Minimum Temperature
Temperature limits can be set independently for up to 3 outdoor temperature sensors.
Long press the ALERT(C) button. The value for setting maximum temperature alert will begin flashing
Use the MEM and HISTORY buttons to set the desired temperature between -49 °C and 70 °C.
Then press the ALERT(C) button and set the minimum temperature for the alert between -50 °C and
69 °C .
Press the ALERT button to activate/deactivate the temperature alert function. The icon will appear
in field no. 26.
Holding the adjustment buttons will make the values change faster.
Temperature limit range is -50 °C to +70 °C, increment 1 °C.
When the set temperature limit is exceeded, an audio alarm will sound repeatedly and the value will
begin flashing.
Pressing the ALERT button silences the audio signal.
Battery Replacement Warning
Replace the batteries in the station or the sensor once the display of the station or the sensor shows
the low battery icon .
Station Display Backlight
When powered via adapter
Permanent backlighting is set automatically.
Repeatedly pressing the SNOOZE•LIGHT button will allow you to set 3 different modes for permanent
backlighting (off, medium backlight level, maximum backlight level.)
When powered by 3× 1.5 V AAA batteries
Display backlighting is off. Pressing the SNOOZE•LIGHT button will turn the display backlight on for 10
seconds, then it turns off again. When the station is only powered by batteries, permanent backlighting
of the display cannot be activated!
Note:
The inserted batteries serve as backup for the measured/set data.
If batteries are not inserted and you unplug the adapter, all data will be erased.
8