Audio Inputs - Yamaha NX-B02 Bedienungsanleitung

Audio inputs

1 When using Bluetooth connection
Pairing must be performed when using Bluetooth
connections for the first time or if the pairing data has been
deleted. "Pairing" refers to the operation of registering
mobile phones, etc., for Bluetooth communications
(hereafter referred to as "other components"). Use the
procedure described below to pair.
y
To ensure security, a time limit of 8 minutes is set for the
pairing operation. You are recommended to read and fully
understand all the instructions before starting.
1
Turn on the power of the other component
you want to pair with.
2
Press to turn this unit on.
3
Press and hold
This unit is set to the pairing mode (the status indicator
flashes in blue).
4-a
[For components with input keys (mobile
phones, computers, etc.)]
Operate the other component to detect
Bluetooth components.
For details, refer to the other component's operating
instructions.
2 When using analog input
PORTABLE IN jack
Commercially available 3.5 mm
stereo mini plug cable
for more than 4 seconds.
4-b
[For components without input keys
(Bluetooth adaptors, etc.)]
Set the other component to the pairing
mode and then proceed to step 7.
For details, refer to the other component's operating
instructions.
5
Select "NX-B02 YAMAHA" from the list of
the other component.
6
If you are asked to input a passkey, input
the number "0000".
7
Check that pairing is completed.
The status indicator flashes quickly, indicating that the
pairing process on this unit has been completed. Check
that the pairing process on the other component has also
been completed. If the status indicator does not flash
quickly or if the pairing process on the other component
fails, start over from step 3.
Notes
• Bluetooth communications with other components are not
possible while this unit is in the pairing mode. If the
pairing mode is set accidentally, press
the pairing mode.
• This unit can be paired with up to eight other components.
When pairing is conducted successfully with a ninth
component and the pairing data is registered, the pairing
data for the least recently used other component is cleared.
• If the power supply to this unit is cut off during the pairing
operation, the pairing data may be damaged. If so, perform
the procedure described at "Clearing the pairing data" on
page 4 and then perform pairing again.
Connect an audio output jack of your
portable audio player and the PORTABLE IN
jack of this unit using a commercially
available 3.5 mm stereo mini plug cable.
Note
Before connecting, make sure that this unit is turned off.
shortly to cancel
3
En