Attaching/changing the Velcro
sandpaper
Pull out the mains plug.
Remove worn sanding tool from
the backing pad.
Place the Velcro sandpaper in the centre
of the backing pad and press on.
Note position of the holes to ensure that
the sanding dust is extracted.
Conduct a test run to check that the sanding
tool is clamped in the centre.
Working with flap sanding discs
klqb
cä~é=ë~åÇáåÖ=ÇáëÅë=~êÉ=~=ÅçãéçåÉåí=çÑ=íÜÉ=
"jÉí~ä=ïçêâáåÖÒ=~ÅÅÉëëçêó=ëÉíK
Pull out the mains plug.
Press and hold down the spindle lock.
Loosen the Velcro pad by hand or using
a two-hole wrench.
klqb
fÑ=íÜÉ=sÉäÅêç=é~Ç=áë=ëíìÅâI=ÜçäÇ=íÜÉ=ÖÉ~ê=ëÜ~Ñí=
áå éä~ÅÉ=ìëáåÖ=~å=^ääÉå=âÉóK
Screw Velcro pad anti-clockwise
off the spindle.
22
SE 14-2 125/SE 14-2 150
Place clamping flange (A) on spindle.
Place flap sanding disc (B) on clamping
flange.
Screw the clamping nut (C), with flange
face up, onto the spindle.
Press and hold down the spindle lock.
Tighten clamping nut clockwise using
the holding wrench.
Conduct a test run to check that the sanding
tool is clamped in the centre.
`^rqflk>
kÉîÉê=ìëÉ=~=Çá~ãçåÇ=ë~åÇáåÖ=ÇáëÅ=åçí=
~ééêçîÉÇ=Äó=cibu=çå=íÜáë=ÉäÉÅíêáÅ=éçïÉê=íççäK=
oáëâ=çÑ=Ç~ã~ÖáåÖ=íÜÉ=ÇÉîáÅÉ>