Before First Use; Charging The Device - Blaupunkt RVC701 Bedienungsanleitung

RVC701
Input amperage: max. 400mA
Output voltage: 24V
Output amperage: 600mA
1. Control panel
1a. Power button
1b. HOME button
1c. PLAN button
1d. Display
2. Large pull-out dust bin
2a. Bin cover
2b. Bin opening lock
2c. HEPA filter
2d. Prefilter
3. Pull-out dust bin with an integrated water tank
3a. Water inlet
3b. Water pump
3c. Dust bin handle
3d. Dust bin latch
3e. HEPA filter
4. Bumper
5. Front wheel
6. Drive wheels
7. Collector brushes
8. Suction opening
9. Main collector brush

BEFORE FIRST USE

1. Remove all the paper, carton and foil protecting the vacuum and its parts.
2. Install the collector brushes. Press the brush marked with L or R into the appropriate location
marked L or R.
3. Make sure that the main collector brush is installed correctly.
4. Put the dust bin in the robot.
5. Place the charging station in a convenient location and connect it to the mains. It is
recommended to leave a free space around the station, 1 meter to the sides and 2 meters at the front.
1m
1m
2m
6. Charge the device battery according to the instructions.

CHARGING THE DEVICE

1. Plug the power supply plug into the charging station, then plug the power supply into an electrical
socket. A blue LED will indicate that the station is correctly connected.
2. Switch the vacuum cleaner on with the main switch.
3. Place the robot vacuum cleaner on the charging station so that the charging connectors touch the
10. Main collector brush cover
11. Surface-edge sensors (Anti-fall)
12. Main switch
13. Charging socket
14. Robot charging connectors
15. Charging station
16. Remote control
16a. Display
16b. HOME button
16c. Direction buttons (allow the robot to
move in the indicated directions; only
works in standby mode)
16d. MAX button
16e. CLK button – sets the robot's timer
16f. PLAN button – allows you to schedule
the robot's operating hours
16g.ON/OFF button – once pressed, the
robot starts cleaning or enters standby
mode
16h. MODE button – allows you to select
the operating mode
4