Fuel Safety - Husqvarna K1270 II R Bedienungsanweisung

3. Make sure that the throttle trigger and throttle trigger
lockout move freely and that the return springs
operate correctly.
4. Start the product and apply full throttle.
5. Release the throttle control and make sure that the
cutting blade stops and stays stationary.
6. If the cutting blade rotates at idle position, adjust the
idle speed. Refer to
17 .
To do a check of the stop switch
1. Start the engine.
2. Push the stop switch to the STOP position. The
engine must stop.
Vibration damping system
Your product is equipped with a vibration damping
system that is designed to minimize vibration and make
operation easier. The product's vibration damping
system reduces the transfer of vibration between the
engine unit/cutting equipment and the product's handle
unit.
6
To adjust the idle speed on page
To do a check of the vibration damping
system
WARNING: Make sure that the engine is off
and that the stop switch is in STOP position.
1. Make sure that there are no cracks or deformation
on the vibration damping units. Replace the vibration
damping units if they are damaged.
2. Make sure that the vibration damping units are
correctly attached to the engine unit and handle unit.
Muffler
The muffler keeps the noise levels to a minimum and
sends the exhaust fumes away from the operator.
Do not use the product if the muffler is missing or
defective. A defective muffler increases the noise level
and the risk of fire.
WARNING: The muffler becomes very hot
during and after use and when the engine
operates at idle speed. Be careful near
flammable materials and/or fumes to prevent
fire.
To do a check of the muffler
• Examine the muffler regularly to make sure that it is
attached correctly and not damaged.

Fuel safety

WARNING: Read the warning instructions
that follow before you use the product.
• Fuel is flammable and the fumes are explosive. Be
careful with fuel to prevent injury, fire and explosion.
• Only refuel the product outdoors, where the airflow is
sufficient. Do not breathe in the fuel fumes. The fuel
fumes are poisonous and can cause injury, fire and
explosion.
• Do not remove the fuel tank cap or fill the fuel tank
when the engine is on.
• Let the engine become cool before you refuel.
• Do not smoke near the fuel or the engine.
• Do not put hot objects near the fuel or the engine.
• Do not fill fuel near sparks or flames.
• Before you refuel, open the fuel tank cap slowly and
release the pressure carefully.
• Fuel on your skin can cause injury. If you get fuel on
your skin, use soap and water to remove the fuel.
• If you spill fuel on your clothing, change clothing
immediately.
• Tighten the fuel tank cap fully. If the fuel tank cap is
not correctly tightened, the vibrations in the product
1390 - 001 - 10.01.2020