Sanotechnik PR150 Montageanleitung Seite 22

Plug it in
1.
Press the "switch" key to switch on the control power supply
2.
press the "floodlight" key, the indicator will light and the floodlight will
3.
work. Repress to turn off
Press the "fan" key, the indicator will light and the fan will start to work.
4.
Repress to turn off the fan
Press the "radio" key to turn on the FM radio, and the indicator will light.
5.
Then press the "tune" key, the radio will make automatic tuning from the
low frequency end to the high frequency end. When it searches any radio,
it will stop at that frequency band. When it searches to the high end
(108,8MHz)
You should press the "reset" key to turn it to be the low end (88MHz).
6.
Then press the "tune" key, the radio will begin to make automatic tuning
from the low end to the high end again: repress the "radio" key to turn off
the radio.
Press the "Volume up or down" key to adjust the volume and the level indicators changes accordingly.
7.
press "switch" key after use to power it off.
8.
Safety Guideless:
1. the computer panel should be installed by the qualified instruction person
2. the electrical parameters of the product should conform to the relevant national standards.
3. the voltage of the power supply is AC 230+/-10%
4. please power off the control after each use . Unplug it when it will not be used for a long time.
5. the leakage protection device must protection device must be provided by the user.
NOTE: Without the permission of the manufacturer. The controller will not be guaranteed for any
Damage resulting from the alteration of circuit or connection of electrical equipments.
REMOTE CONTROL RADIO
INSTRUCTION FOR RADIO: