Switching The Bridge Zone On; Special Cooking Function - Sharp KH-6I27CS00-EU Bedienungsanleitung

corresponding cooking zone display.
Blinking is active for 3 seconds and
allows further adaptations of the
settings before power reduction.

Switching the bridge zone on

Touch the front left and rear left heater
selection key simultaneously. There is
a static dot indication
on the left heaters displays and
displays Show the 'b' and 'r'. And the
blinking dot on the all other
displays turned off..
Select the temperature setting by using
the increase heat setting with right side
of the sliding button
or decrease heat setting with left side
of the sliding button.
The bridge element is ready to cook.
For quickest boil time, select desired
cooking level and then
touch the P key to activate Boost
function.
Switching the bridge zone off
Bridge element shall be selected by
pressing the rear left or front left heater
selection key with using
left side of the sliding button key, turn
the level down to ''0''. If the bridge
cooking zone is hot, "H" will
be displayed .

Special cooking function

Touch the heater selection key
consecutively for boiling,frying,keep
warming,chocolate
melting.Special cooking function is
avaible only for right side of hob.
Boiling and frying can't work
simultenaously but after you heard one
beep from hob it is possible to activate
boiling and frying
simultaneously.
Boiling function**
This function allows for the boiling of
water and keeping it near the boiling
point. To activate the boiling function
press the heater selection key twice.
When the boiling function is active, the
related display shows a 'b'. After boiling
the water, the hob gives a beep signal.
This signal shows that the boiling is
finished
simmering is taking place.
The rear right heater display indicates
the boiling function
Frying function
This function provides the frying of oil
at around 160°C. To activate the frying
function, press the
heater selection key three times. When
the frying function is active, the related
display shows an 'F'. The hob gives a
beep signal after a while. This signal
shows the oil is ready to fry.
The front right heater display indicates
the frying function
EN- 12