Description Of Parts - Telcoma T10 FM400 Gebrauchs- Und Programmierungsanleitung

DESCRIPTION OF PARTS

Fig. 1
1 Aerial wire
2. Jumper configurations
3. LED
4. Programming button
5. Buzzer
6 Terminal board for input of control buttons.
7 Motor-lights power supply / output terminal board
RECOMMENDATIONS
- Switch off power supply before making the electrical wirings.
- Failure to comply with these instructions may affect the proper
functioning of the equipment.
The company TELCOMA S.r.l. disclaims any liability for any
malfunction and / or damages resulting from failure to follow these
instructions.
The equipment must be installed according to the principles of good
workmanship by personnel with qualifications as envisaged by current
legislation and incompliance with the standards EN12453 and EN12445
governing safety of the automation.
ELECTRICAL CONNECTIONS AND OPERATING MODES
Recommendations for correct electrical wiring:
-The cable section must be calculated according to the length of the cables
and maximum current.
-Do not use a single multipolar cable for the motor and control power
supply. The controls must have a separate cable.
GB
25