Replacing/Installing The Side Brushes; Replacing The Centre Brush - VLX 818R Bedienungsanleitung

REPLACING/INSTALLING
THE SIDE BRUSHES
To facilitate transport, the side brush (or
position. To install the side brush in the correct
position, proceed as follows:
• move the side brush control lever to the
up position.
• unscrew the screw on the side brush
motor shaft.
• remove the key protector.
•
the shaft.
•
15).
To replace worn side brushes, carry out the
operations listed above.
REPLACING THE CENTRE
BRUSH
This machine features a system for
automatically adjusting the pressure exerted
and compensating for the central brush wear.
The need to replace the centre brush is
indicated by the BRUSH WORN code on the
display.
To replace the centre brush, proceed as
follows:
• Unscrew the knob and open the door
• Unscrew and remove the three
• Remove the cover of the brush
compartment.
•
• Remove the adapter from the core
new brush, taking care to keep
the bristles aligned in the same
direction.
• Fit the new brush and make sure
that the adapter is inserted on the
drive hub.
• Replace the brush compartment
cover, following the dismantling
operations in reverse order.
EN 15