VLX 818R Bedienungsanleitung Seite 30

• Do not bump against shelves or
falling over.
• In areas where the operator could be
struck by objects falling from overhead,
do not use the machine without a FOPS
(Falling Object Protective Structure)
• Do not use the machine as means of
transport.
• Never use the machine to clean up
fuel oil, etc.), acids or solvents (e.g. paint
solvents, acetone etc.) even if diluted.
• Never clean up burning or incandescent
objects.
• Adapt the speed of the machine to the
• Avoid using the machine if its stability is
not guaranteed.
•
extinguisher, DO NOT USE WATER.
• Do not use solvents or similar substances
to clean the machine.
• Do not wash the machine by spraying
directly with water or using high pressure
water jets.
• Do not remove any guards that require
the use of tools to be removed.
• NEVER use the machine without its
guards. For your safety, make sure all
guards are closed or correctly mounted
before starting the machine.
• If you notice that the machine is not
working properly, make sure this does not
depend on failure to carry out the routine
maintenance operations. If this is not your
case, contact unauthorised service centre.
• Always use the battery charger supplied
by the manufacturer, or alternatively, a
by a third party body in accordance with
the latest edition of the pertinent standard
(EN 60335-2-29). The charger must
be equipped with double or reinforced
insulation between input and output
and with a SELV type output circuit with
maximum 24V output voltage.
• Make sure the battery charger is
compatible with the batteries to be
charged.
• Make sure that the power socket used
for the battery charger is connected to a
suitable earth system and protected by
thermal overload and residual current
circuit breakers.
• Make sure the electrical characteristics of
the battery charger (voltage, frequency,
absorbed power) given on the rating plate
are the same as those of the mains power
supply.
• Check the battery charger power cable
regularly for damage. If the power cable is
damaged, do not use the charger.
• If replacing parts, order ORIGINAL
spare parts from an authorised dealer or
reseller.
• Maintenance operations on the electrical
circuit and in any event all other
operations not explicitly described in this
operating manual must be performed
by maintenance personnel only, in
compliance with current safety regulations
and as indicated in the maintenance
manual.
• Always disconnect the power supply
to the machine before carrying out any
maintenance.
• Every 200 hours of work, have the
machine checked by an authorised
service centre.
waste and is covered by the requisites of the
new environmental protection regulations
(2002/96/EC WEEE). It must be disposed of
separately from ordinary waste in compliance
with current legislation and standards.
EN 6