Mounting Guidelines - Honeywell IDENT-KEY 3 Montage, Anschluss, Anleitung

Mounting and Connection Instructions IK3 Operating Unit with Keypad
4.2

Mounting guidelines

The IK3 operating unit is suitable for indoor and outdoor use. Mount directly on the wall or use a
"standard f.m. socket". The electronic unit is inserted in the back of the housing and locked into
position with the housing front (replaceable).
For mounting surfaces of metal, the transmission range of the transponder may be lower
than that of non-metallic surfaces. In this case, we urgently recommend adjusting the
range (see 6.4).
In order to operate and read the keypad optimally, install the operating unit at a
140 cm above the floor.
When used outdoors, do not expose the operating unit directly to the weather!
If necessary, use the plastic housing (weather/view) Item no. 023501.
To mount, lift the housing front at the bottom and unhook at the top. When installing the housing back,
remove the electronics to avoid damage.
The housing back has two 60 mm boreholes for wall and f.m. sockets. To fix securely, use screws that
are suitable for the mounting surface in question.
- In masonry with S6 plug:
- In wood, depending on type: Semi-circular wood screw with slot 3.5 x 45 to 3.5 x 60 mm
- In metal :
- On the standard s.m. socket Semi-circular wood screw with slot 3.0 x 40 mm and washer
For additional fixing, the third borehole can be used (see 4.1). Choose the correct screw length for
the mounting surface.
When mounting, feed the connecting cable, if possible, from the back through an empty pipe
allowing sufficient spare cable.
Attention!
If the operating unit is to be used
outdoors, the cable bushing must be
sealed on both sides
(e.g. with plaster
condensation from forming!
When mounting on an f.m. socket or
on a cavity wall, install the socket so
that the fixing holes are horizontal
(see illustration).
To lock the housing
seals at the bottom. The housing cannot be opened
without destroying the seal.
E.g. semi-circular wood screw with slot 3.5 x 60 mm
Fillister head screw M3 x 30 mm (min.) with washer
of the wall,
) to prevent
press in one of the enclosed
Fixing holes
60 mm
Observe notches
19
height of 130 to