Transport; Storage; Disposal - Dräger FPS 7000 Gebrauchsanweisung

9. Place the cap on the connector, snap it into the fixing lugs and
hook it into the visor frame.
NOTICE
i i
The cut-out for the connector varies depending on the
facepiece.
Make sure that the following caps are used:
for P and RA facepieces: cap R 56 278
for PE and ESA facepieces: cap R 56 378
10. Attach the inner mask.
4.4.8 Replacing the head harness
NOTICE
i i
A hairnet can also be used instead of the head harness. The
hairnet has the same clips as the head harness.
Remove the head harness as follows (Figure J1 on Page 3):
1. Turn the head harness away from the flap on the mask.
2. Push the clip on the head harness towards the visor.
Attach the head harness to the mask as follows (Figure J2 on Page 3):
Place the clip on the mask flap and push it onto the latch.

Make sure that the nose on the flap is correctly engaged in the hole
in the clip.
Dräger FPS 7000
5

Transport

Transport the facepiece in a carrying box or mask bag.
6

Storage

Loosen the harness as far as possible.

Make sure that the facepiece is dry.

Pack the full face mask in its bag or carrying box.

Store the full face mask in a dry, dust-free place where it cannot

become deformed.
Protect from direct sunlight and thermal radiation.

Storage temperature: –15 °C to +25 °C

Observe ISO 2230 and national regulations concerning the

storage, maintenance and cleaning of rubber products.
Dräger rubber products are treated with an agent to protect against
premature ageing which in some cases is visible as a grey-white
coating. This coating can be washed off with a brush and soapy water.
7

Disposal

Dispose of the facepiece and used filters according to the applicable
regulations.
(approved by Dekra Exam)
Transport
31