Husqvarna K1270 II Bedienungsanweisung Seite 32

13. Pull the starter rope through the starter rope handle
and make a knot at the end of the starter rope (A).
A
B
14. Attach the cover on the starter rope handle (B).
15. Adjust the tension of the recoil spring. Refer to
adjust the tension of the recoil spring on page 32 .
To adjust the tension of the recoil
spring
1. Pull out the starter rope.
2. Put the starter rope in the notch and wind it up
around the metal sleeve.
32
3. Pull out the starter rope (A).
C
To
4. Put your thumb on the starter pulley (B) to keep the
starter rope pulled out.
5. Release the starter rope from the notch (C).
6. Remove your thumb to release the starter pulley (A)
and let the starter rope (B) wind up on the pulley.
7. Pull out the starter rope fully to do a check that the
recoil spring is not at its end position. Make sure that
the starter pulley can be turned half a turn or more
before the recoil spring stops the movements.
To remove the spring assembly
WARNING: Always use eye protection when
you disassemble the spring assembly. There
A
B
B
B
A
988 - 002 -