Connecting The Camera - Smartwares IAN 281517 Montage-, Bedienungs- Und Sicherheitshinweise

Connecting the camera (see Fig. B)
Connect the Ethernet cable
Plug the connector of the power supply
Plug the power supply
is too short, please contact our service department (see „Service
Address" for the address) to order the 1.8 m low voltage cable
model number EXT180 to extend it.
Wait about 45 seconds after connecting to the electric circuit. Once
the red and green LED on the camera light up, it is connected to
the network.
The red LED indicates the camera is connected with the power
supply. The green LED indicates the camera is connected with the
router.
Note: To use the camera to record, insert an SD card in the SD slot
(see Fig. B).
Open the rubber cover.
Slide the SD card, pins down, into the SD slot
Carefully push the SD card against the resistance of the spring.
The SD card is now locked in place.
To remove the SD card, lightly push against the SD card using
your fingernail.
The spring will now slightly push the SD card out of the SD slot
The SD card can now be removed.
Close the rubber cover to prevent water from entering.
with the router.
8
into the socket. If the connecting cable
7
into the camera
7
.
11
GB/MT
.
1
.
11
35