Smartwares IAN 281517 Montage-, Bedienungs- Und Sicherheitshinweise Seite 32

Now drill the mounting holes (Ø 5 mm). Ensure that you do not
damage the supply line.
Drill an additional hole (approx. ø 18 mm) into the middle of the
three mounting holes.
Feed the camera connecting cable through one of the three cable
guides in the mounting bracket .
2
Loosen the wing bolt on the mounting bracket and adjust the
2
viewing angle (see Fig. A2).
Then secure the joint by tightening the wing bolt.
Screw the camera onto the mounting bracket (see Fig. A3).
1 2
Feed the camera connecting cable through the bore.
Now insert the wall plugs into the bores.
5
Secure the mounting bracket to the wall using the screws
2 6
(Fig. A1).
RJ45
Once the you have turned the camera on the screw in the mounting
1
bracket so it is connected as tight as possible, turn the triangle
2
nut in the opposite direction to secure the camera .
1
Note: For details and more information, please refer to the in-
cluded tutorial CD .
4
34 GB/MT