KaWe MedCenter 5000 Gebrauchsanweisung Seite 20

Guidelines and MANUFACTURER-Declaration – ELECTROMAGNETIC INTERFERENCE IMMUNITY
The KaWe MedCenter® 5000 is designed to be used in the types of ELECTROMAGNETIC ENVIRONMENTS listed below.
The customer or user N15) is responsible for ensuring that this device is used in such an environment.
IEC 60601-TEST
IMMUNITY TEST
LEVEL
Conducted HF-
interference
3 V rms
according to
150 kHz to 80 MHz
IEC 61000-4-6
3 V/m
HF-interference
80 MHz to 2.5 GHz
according to
IEC 61000-4-3
NOTE 1: For 80 MHz and 800 MHz, the larger of the two values applies.
NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from
structures, objects and people.
Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land mobile radios, amateur radio,
AM and FM radio broadcast and TV broadcast cannot be predicted with accuracy in theory. It is recommended that in order to assess the
ELECTROMAGNETIC ENVIRONMENT caused by fixed HF transmitters, an electromagnetic site survey should be conducted. If the measured
field strength at the location at which the KaWe MedCenter® 5000 is used exceeds the applicable compliance level stated above, the equip-
ment should be checked at each of its locations of use in order to verify normal operation. If abnormal performance is observed, additional
measures may be necessary, such as reorienting or relocating the KaWe MedCenter® 5000.
For frequencies ranging from 150 kHz to 80 MHz, the field strength is less than 3 V/m.
CONFORMITY ELECTROMAGNETIC ENVIRONMENT –
LEVEL GUIDELINES
Portable and mobile HF communications equipment should
be used no closer to the KaWe MedCenter® 5000 (including
its power cords) than the recommended separation distance.
The separation distance is calculated using various equations
depending on the transmission frequency.
Recommended separation distance:
d = 1.2 √P
3 V rms
d = 1.2 √P 80 MHz to 800 MHz
3 V/m
d = 2.3 √P 800 MHz to 2.5 GHz
"P" is the maximum output power rating of the transmitter
in watts (W) according to the transmitter manufacturer. "d"
is the recommended separation distance in meters (m).
Field strengths from fixed transmitters, as determined by an
electromagnetic survey of the site are less than the COMPLI-
ANCE LEVEL in each frequency range.
Interference may occur in the vicinity of equipment marked
with the following symbol:
20