Operation / Settings - GRAPHITE 58G071 Betriebsanleitung

Use the hex key to loosen screw that fixes the blade shaft (fig. A).
Slide blade into clamp, push to the limit.
Blade's teeth should point forward.
Tighten the screw with the hex key (fig. A).
Ensure the blade is properly fitted in the guide roller (10) (fig. A).
Blade removal is similar to installation, only the sequence of actions is reversed. Ensure the tool is discon-
nected from the power supply before blade removal.
Use blades suitable for clamp mechanism shown on fig. F.
DUST EXTRACTION
To improve dust extraction from processed surface the jigsaw is equipped with own dust blow-off and extrac-
tion system, which cleans the surface being cut. Dust blow-off and extraction system is more efficient when
the jigsaw guard is lowered.
SWITCHING ON / SWITCHING OFF
Before connecting the jigsaw to a power supply always check that power supply voltage matches
rated voltage on the rating plate fixed on the power tool.
Switching on – press the switch button (2) and hold in this position (fig. B).
Switching off – release pressure on the switch button (2).
Locking the switch (continuous operation)
Switching on:
Press the switch button (2) and hold in this position.
Press the switch lock button (3) (fig. B).
Release pressure on the switch (2).
Switching off:
Press and release the switch (2).
CONTROL OF JIGSAW OPERATING SPEED
You can control rotational speed of jigsaw motor by turning and setting the wheel for operation speed
control (1) in desired position. It allows to adjust the power tool working speed to match characteristics of
processed material. Speed control ranges from 1 to 6.
The bigger the number on the wheel rim (1) (fig. C), the greater the jigsaw operation speed.
BLADE PENDULUM ACTION CONTROL
Besides to-and-fro movement control there is also possibility to set blade pendulum action level. It allows
for better adjustment of the tool operation parameters to type of processed material. Pendulum action is
controlled with wheel (6). Set the wheel for pendulum action to 0 when using knife blade. Lubrication is
recommended for metal cutting. The below table gives the best choices for pendulum action setting.
Sheet metal plate, generally: 0
Sheet aluminium:
Plywood:
FOOTPLATE ADJUSTMENT FOR BEVEL CUTTING
Disconnect the power tool from power supply.
Lift the blade guard and loosen screws that fix the footplate (5) with the hex key.
Move the footplate to the back (fig. E).
Set the footplate to appropriate angle (use the scale).
Move the set footplate to the front.

OPERATION / SETTINGS

Steel sheet:
I – II Plastics:
0 – I Wood:
14
0 – I
I – II
I - III