GRAPHITE 58G071 Betriebsanleitung Seite 12

TRANSLATION OF THE ORIGINAL INSTRUCTIONS
CAUTION: BEFORE USING THE POWER TOOL READ THIS MANUAL CAREFULLY AND KEEP IT FOR FUTURE
REFERENCE.
Use dust-masks when cutting to protect your respiratory system against dust that appears.
Check the processed material thoroughly before cutting to eliminate possibility of cutting nails, bolts,
or other hard objects.
Do not cut pipes with the jigsaw.
Do not cut objects thicker than allowed in technical specification for a given material.
Prior to operation ensure there is enough space under processed material to avoid table or floor damage
with the blade.
Hold the jigsaw in a closed hand.
Before pressing the switch ensure the jigsaw does not have contact with the material .
Do not touch moving parts.
Before cutting floor, wall or other material ensure it does not contain conductors.
Do not put away the jigsaw until it stops moving. Do not switch the jigsaw on when not holding it.
To remove the blade switch the jigsaw off with the switch and wait until the blade stops moving. Then
disconnect the tool from mains socket.
Do not touch the blade or processed material immediately after finishing the work. Those elements may
be hot and may cause burns.
When you see unusual behaviour of the tool or hear strange noises, immediately switch off the tool and
remove the plug from mains socket.
To ensure proper cooling keep ventilation holes in the jigsaw body unobstructed.
CAUTION! This device is designed to operate indoors.
The design is assumed to be safe, protection measures and additional safety systems are used, ne-
vertheless there is always a small risk of operational injuries.
SAFETY RULES FOR LASER DEVICE
Laser device used in the power tool design is the class 2 with maximum power below 1mW and wavelength
650 nm. Such device is not dangerous to your sight, however do not look directly at the source of the light
(temporary blindness hazard).
WARNING. Do not look directly at the laser beam. It may cause hazards. Follow the below mentioned safety
rules.
Use the laser device in accordance to the manufacturer's instructions.
Do not, either intentionally or unintentionally, point the laser beam at people, animals or any object
other than processed material.
Do not bring to accidental pointing the laser beam at outsiders' or animals' eyes for a period longer than
0.25 second, for instance by pointing the laser beam at mirrors.
Always ensure the laser beam is directed at material, which does not have any reflective surfaces. Reflec-
tive steel sheet does not allow for laser use, because it might cause hazardous light reflection directed at
operator, outsiders or animals.
Do not replace laser assembly with device of other type. Any repair should be carried out by the manu-
facturer or authorized person.
BLADE SAWING MACHINE (JIGSAW)
58G071
DETAILED SAFETY REGULATIONS
12