JGC RRMP-3400 Bedienungsanleitung Seite 22

TAPE DECK
TAPE DECK
GENERAL OPERATION (Keys from left to right)
Press together with
RECORD
Press to start playing tape.
PLAY
Press to start the tape winding in a forward direction.
FAST FORWARD
Press to start the tape winding in a reverse direction.
FAST REWIND
Press to stop all cassette play operation. Press again to open the cassette door.
STOP/EJECT
Press to interrupt recording or playback.
PAUSE
PLAYBACK
1. Slide the switch to TAPE.
FUNCTION
2. Insert a pre-recorded cassette tape.
3. Press button to start playback.
PLAY
4. Adjust the volume control to the desired listening level.
5. Press button when you want to stop playback temporarily.
PAUSE
6. Press button to terminate the playing.
STOP/EJECT
RECORDING
RECORDING FROM RADIO
1. Slide the switch to RADIO.
FUNCTION
2. Tune to the desired station and insert a blank cassette tape.
3. Press and
RECORD PLAY
4. Press button to interrupt the recording or the
PAUSE
RECORDING FROM CD
1. Slide the switch to CD.
FUNCTION
2. Insert a blank cassette tape for recording.
3. Press and
PAUSE RECORD
4. Activate the CD player, and then press the
5. To stop recording, press the
NOTE: Pressing and
RECORD
GENERAL INFORMATION ON RECORDING
•
Recording is permissable in so far as copyright or other rights of
third parties are not infringed.
•
This deck is not suitable for recording on CHROME (IEC II) or
METAL (IEC IV) type cassettes. For recording, use NORMAL (IEC I)
type cassettes on which the tabs have not been broken. The best
recording level is set automatically. Altering the VOLUME will not
affect the recording in progress.
•
At the very beginning and end of the tape, no recording will take
place during the 7 seconds, when the leader tape passes the
recorder heads.
•
To protect a tape from accidental erasure, have the tape in front of you and break out the left tab. Recording on this
side is no longer possible. To record over this side again, cover the tab hole with a piece of adhesive tape.
•
Use the BEAT CUT switch at the back of the main unit to suppress beat pulses while recording and receiving AM
radio. the beat pulses may influence the recording level.
22
button to start tape recording.
PLAY
button to start recording.
buttons together. The recording function is now on stand-by mode.
button to start recording.
PAUSE
button first and then press the
PAUSE
together will automatically resume a paused CD playback
PLAY
button when finished recording.
STOP/EJECT
button on the CD player.
STOP