Location Of Controls - Jgc Rrmp-3400 Bedienungsanleitung

1. switch
FUNCTION
2. button
REPEAT
3. control
VOLUME
4. buttons
SKIP/SEARCH
5. button
STOP
6. switch
DBBS
7. LC Display
8. FM Stereo indicator
9. CD Compartment
10. control
TUNING
11. button
MEMORY
12. switch
BAND
13. button
CD PLAY/PAUSE
14. Tape deck cassette holder
15. Tape deck button
PAUSE
16. Tape deck
STOP/EJECT
17. Tape deck button
FF
18. Tape deck button
REW
19. Tape deck button
PLAY
20. Tape deck button
RECORD
21. Remote control sendor
22. buttons
FOLDER
23. FM telescopic antenna
24. BEAT CUT switch
25. Headphones jack
26. Speaker terminals
27. Speacker release levers
28. (omitted)
29. AC IN connector
30. Battery compartment
CAUTION:
Usage of controls, adjustments, performance or procedures other than those specified herein may result in hazardous
radiation exposure. This unit should not be adjusted or repaired by anyone except a qualified service person.
PRECAUTIONS FOR USE
INSTALLATION
Unpack all parts and remove protective material. Do not connect the unit to the power outlet before checking the
voltage and before all other connections have been made. Do not cover any vents and make sure that there is a space
of several inches/centimeters around the unit for ventilation.
CONNECTION
1. Connect the power cord to AC outlet.
2. When you first plug the unit into the power outlet, the unit will go into standby mode, the display will blink the
un-set clock.
3. Connect the speaker wire to the speaker terminal located on the rear side of the unit.
4. Turn on the power. If the LCD display is on with backlighting, it means the power supply is normal and your
system is ready to play music.

LOCATION OF CONTROLS

button
17