Set-Up And Operation Instructions - RIDGID RS-570 Bedienungsanleitung

• Any broken, worn, missing, misaligned or
binding parts. Confirm that all fasteners
are secure. Inspect centering pin (Figure
7) for presence and damage.
• Proper operation of two step momentary
ON/OFF switch – see Figure 9.
• Support device. Confirm it is clean, in good
condition and functioning properly. Inspect
chain for any separation of links or other
damage. Link separation indicates the
chain has been overloaded and should be
replaced.
• Presence and readability of warning label.
See Figure 4.
• Any other condition which may prevent
safe and normal operation.
Do not use the tool until any problems have
been repaired.
Figure 4 – Warning Label
Set-up and Operation
Instructions
WARNING
Hold the power tool (reciprocating saw) by
insulated gripping surfaces, when per-
forming an operation where the cutting
accessory may contact hidden wiring or
its own cord. Cutting accessory contact-
ing a "live" wire may make exposed metal
parts of the power tool "live" and could
give the operator an electric shock.
Use clamps or another practical way to
secure and support the workpiece to a
stable platform. Holding the workpiece by
hand or against your body leaves it unsta-
ble and may lead to loss of control.
Keep bystanders clear of work area. Guard
or barricade minimum of 6 feet (2 meter)
around the working area. Particles or bro-
999-995-148.08_REV. B
RS-570 Reciprocating Saw
ken saw blades can be thrown and
cause injury beyond immediate area of
operation. A guard or barricade that pro-
vides a clearance around the work piece
will reduce the risk of injury.
Keep hands away from reciprocating
saw blades. Allow blade to come to a
complete stop before handling the blade
or workpiece. This practice will reduce
the chance of entanglement in moving
parts.
Always use the support device provided
with the tool. Properly support the work
piece. Make sure the work piece is se-
cured to a stable platform. Loss of con-
trol during operation can result in per -
sonal injury.
Do not cut unless there is proper clear-
ance beyond the workpiece being cut.
The blade may cause the tool to kick-
back if it strikes a hidden object and
may damage the tool, damage the at-
tachments and/or cause personal injury.
Use caution when working overhead.
Anticipate the path of falling material
and debris ahead of time.
Do not use dull or damaged blades. Bent
blade can break easily or cause kick-
back resulting in damage to the tool,
workpiece and/or cause personal injury.
Before starting to cut, turn the saw "ON"
and allow the blade to come to full
speed. Tool can chatter or vibrate if
blade speed is slow at beginning of cut
and possibly kickback.
Do not cut pipe unless fully drained and
depressurized. When cutting into an ex-
isting system, the pipe must be drained
and depressurized prior to cutting. Take
proper precautions for the pipe contents.
This reduces the risk of electrical shock,
explosions and other serious injury.
Always switch the machine off and wait
until the blade has come to a complete
stop before placing the machine down.
Reduces the risk of injury and tool dam-
age.
Follow setup and operation instructions
to reduce the risk of injury from cut and
other causes and to prevent tool dam-
age.
1. Confirm work area is appropriate (See
General Safety Rules). Operate in clear,
level, stable, dry location. Do not use tool
while standing in water.
2. Inspect the work to be done. Determine
the material type, size and clearance
7