Specifications; Standard Equipment; Pre-Operation Inspection - RIDGID RS-570 Bedienungsanleitung

RS-570 Reciprocating Saw
Clamp Handle
Saw Mounting Shaft
Chain
Figure 2 – Support Device

Specifications

Stroke Length .........1.2" (30 mm)
Speed - No Load
Strokes/Minute .........700, 950, 1200, 1500,
Blade Type.................Single and Double Shank
Blade Length.............Maximum 12" (300 mm)
Motor
Voltage.....................230V
Amperage................6.1 Amp
Power.......................1300 W
Frequency ...............50 Hz
Cutting Capacity........Steel/Plastic Pipe: up to 6",
Overall Length
(without blade)...........24" (605 mm)
Width .........................4" (100 mm)
Height ........................4" (100 mm)
Weight .......................7 .7 lbs. (3.5 Kg)
Sound Pressure
(L )* ..........................87 dB(A), K=3
P A
Sound Power
(L )*..........................98 dB(A), K=3
WA
Vibration*...................25 m/s
* Sound and Vibration measurements are measured in accor-
dance with a standardized test per Standard EN 62481-2-11.
6
Bracket
1750, 2050, 2200 settings
110V
13.0 Amp
1300 W
50 Hz
Wood (nail embedded): up
to 200 mm
2 , K=1.5 (Cutting
Wood)
12.3 m/s 2 , K=1.5 (Cutting
Metal Pipe)
- Vibration levels may be used for comparison with other tools
and for preliminary assessment of exposure.
- Sound and vibration emissions may vary due to your location
and specific use of these tools.
- Daily exposure levels for sound and vibration need to be eval-
uated for each application and appropriate safety measures
taken when needed. Evaluation of exposure levels should con-
sider the time a tool is switched off and not in use. This may
significantly reduce the exposure level over the total working
period.

Standard Equipment

Refer to the RIDGID catalog for details on equip-
ment supplied with specific tool catalog num-
bers.
V
A
Figure 3 – Serial Plate ("20yy" = Year of Manufac-
ture. "xx = Week of Manufacture)

Pre-Operation Inspection

WARNING
Daily before use, inspect your Reciprocat-
ing Saw and correct any problems to re-
duce the risk of serious injury from electric
shock, cut injures, attachment failure and
other causes, and prevent tool damage.
1. Make sure that the Reciprocating Saw is
unplugged and inspect the power cord and
plug for damage. If the plug has been mod-
ified, or if the cord is damaged, to avoid
electrical shock, do not use the machine
until the cord has been replaced by a qual-
ified repair person.
2. Clean any oil, grease or dirt from the equip-
ment, especially the handles and controls.
This aids inspection and helps to prevent
the tool or controls from slipping from your
grip.
3. Inspect the reciprocating saw for:
• Proper assembly, maintenance and com-
pleteness.
~
999-995-148.08_REV. B