Indel B SAFE TOP OPEN Gebrauchsanleitungen Seite 27

SAFE TOP OPEN & SAFE DRAWER
LAMP SETTING
Select "SetLamp" then press "OK" or "5" to set the lighting.
Note: every time you change the light setting on a Safe, you will switch it from on to off. There are two setting
positions: on and off. When it is on, the LED will light up automatically on opening the door; when it is off,
it will not light up automatically.
RECORD PRINTING
Select "PrintRecords" and press "OK" or "6". It will now be possible to print the record.
Note: this printing function is only supported in the communication mode V1.0.
COMMUNICATION MODES
Three communication modes are available: IO-A, IO-B, USART and PC.
Note:
1 If the Handheld unit is used to power the Safe, start the Handheld unit first, then connect it to the Safe.
2 IO-A is a communication mode for first-generation Safes.
3 IO-B is a communication mode for second-generation Safes.
4 The PC mode allows the Handheld unit to be connected to the computer. At the same time, install the
corresponding driver software in the computer; the Handheld unit can be used to communicate with the
computer. Via the computer, it can be used to read and print records.
Before use, correctly set the communication mode, or the Handheld unit will be unable to dialogue with the
Safe or the computer.
CONNECTION TO THE SAFE
1 Start the Handheld unit and set the communication mode "IO-A" to "IO-B".
2 Connect the Handheld unit to the Safe.
If the Safe is a first-generation device, the Handheld unit can be used as soon as it is connected. If the Safe
is a second-generation device, press "*" to activate the Handheld unit then use the Handheld unit.
Note: if you are going through the required steps but malfunctioning is observed, the Safe may be a second-
generation device; try pressing "*" to activate the Safe and repeat the operation.
SAFE TOP OPEN & SAFE DRAWER_01-2018
ENGLISH
25