Indel B SAFE TOP OPEN Gebrauchsanleitungen Seite 21

SAFE TOP OPEN & SAFE DRAWER
ENGLISH
INSTRUCTIONS FOR USE
1) Code setting: User code: 4-6 digits. Master code: 6 digits.
2) User code: factory set default code 1234; Master code: factory set default code: 848711.
3) After 3 failed attempts, the keypad will be locked for 15 min.
4) If the event logging function is used, the (Optional) handheld terminal unit can be used to read the latest
125 opening events data.
5) Internal light
OPENING THE SAFE
FIRST OPENING
Install 4 AA batteries in the internal battery compartment.
Press u on the panel to activate the Safe; backlighting will be turned on and the digits will become clearly
visible.
Key in the default code (factory-set code:1234) and u, if the code entry is correct, the panel will read
"OPEN", and then "OPENED".
If the entered code is wrong, the panel will read 'E-CODE' followed by three short beep sounds.
CLOSING THE SAFE
Press the door to close it, press u to activate the Safe, key in the code (4 to 6 digits), then press u once
again; the panel will read "CLOSE" and then "CLOSED" and the door will be automatically locked.
CHANGING CODES
CHANGING THE PERSONAL CODE
After opening the Safe, press u then key in the new code (4 to 6 digits) and press u once again to display
"CLOSED". The new code will now be visible on the display unit - confirming that the operation has been
successfully completed.
An (optional) Handheld unit is available to check the recorded events log or open the Safe in case of
emergency: see the section on Handheld unit use.
CHANGING THE MASTER CODE
WARNING
We recommend changing the default Master Code as the same code is factory-set by the manufacturer
for all its safes. Once you have changed the Master Code, make a note of the new Code and keep
it in a safe place.
With the Safe door open, key in the original Master Code (6 digit code: 848711) and press the RESET key.
The display will read NEW and you can then enter the new Master Code, also 6 digits-long.
Once you have entered the new Master Code, press the u key again. The display will read AGAIN, now
key in the new Master Code a second time and press u again.
If the Master Code has been changed correctly, the display will read DONE.
RECOMMENDATIONS
After changing the code, do not immediately close the door. Carry out the following procedure at least 3
times to make sure that the code actually works.
Press u, backlighting will be turned on, key in the new code and press u, the Safe will beep twice to indicate
correct code entry and "OPEN" will be displayed to indicate that the new code is working.
If the code is incorrect, the Safe will display "E-CODE" and beep 3 times. Carry out the "CODE SETTING"
procedure again to change the code.
EMERGENCY OPENING
If you forget your personal code or cannot open the Safe for any other reason, the emergency key or the
(optional) Handheld unit can be used to open the door.
19
SAFE TOP OPEN & SAFE DRAWER_01-2018