Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1) Pull out the fuse holder at the back of the base.
2) Remove the old fuse and install a new one.
3) Replace the fuse holder.
c) Mounting the Device
• Respect EN 60598-2-17 and all other applicable norms during installation. A qualified person
should install this device.
• The construction to which the device is attached should be able to support 10 times the
weight for one hour without deformation.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when mounting, removing or servicing it. Have a
qualified technician check the device before you bring it into service. Have a qualified
technician check the entire installation once a year.
• Install the device in a location where few people pass by and that is inaccessible to
unauthorised persons.
• Overhead mounting requires extensive experience : calculating work load limits, determining
the installation material to be used... Have the material and the device itself checked from
time to time. Do not attempt to install the device yourself if you lack these qualifications as
improper installation can result in injuries.
• Make sure there is no flammable material within a 50cm radius of the device.
• A qualified electrician should carry out the electric connection.
• Connect the device to the mains with the power plug. Install a switch with a min. distance of
3mm between contacts if the device is to be connected directly with the mains. In general,
lighting effects should not be connected to dimming packs.
• The installation has to be approved by an expert before the device is taken into service.
5. Use
The moving head is controlled through the control box. The latter is activated by an external
DMX input or via the music. The built-in microphone activates the various beams in case of
music-controlled operation.
DIP switch settings :
1 – 9 : determine the address of the controller when used in DMX mode
10
: selects music-controlled operation
11
: reverse pan : this facilitates the programming of the control system e.g. in case of
ceiling mounting
12.
: reverse tilt : this facilitates the programming of the control system e.g. in case of ceiling
mounting.
13
: focus mode : the beams of the moving head become white, which makes them easier to
focus
VDP250MH6
3
VELLEMAN
Werbung
