MARIMEX ProStar 4 Anleitung Seite 39

(CSN 33 2000) and must be furnished with current circuit breaker with tripping
current 30 mA. The pump is not furnished with controller of operation. We recom-
mend to connect it through the device enabling switching the pump on and off
(switching socket for instance).
Installation
Due to higher sealing capacity we recommend to use teflon tape. Apply suitable
grease on the sealing surface before assembly.
1) Placement of pump on the base
• Place the pump on the base as it is shown in the introductory picture
• Insert the two supplied stainless steel screws with washer in the hole bored in the
base and using nuts attach the pump to the base - see fig. 2.1
• After it put the filtration vessel in two holes on the base in a way so that the lock
of lid position, fig. 2.2, is aimed at the pump.
2) Preparation of the vesse
• Disconnect installed buckle from the vessel
• Insert the partition in the vessel by slipping it on side guides, the partition upper
edge must match with vessel upper edge (see fig. 2.4 and 3).
View of filtration vessel without lid
1) Filtration vessel bottom screen
2) Chamber with sand fill
3) Partition (clean water /chamber with sand fill)
4) Chamber for clean water
5) Water inlet from chamber with sand fill
6) Position lock of the lid ( the nose on filtration vessel lid must fit here).
3) Filling the vessel with sand
WARNING!: he level of sand may not go beyond the upper horizontal reinforce-
ment of the interior partition. Maximum volume of sand fill must not be bigger
than 17 kg.
• Before putting the sand fill the filtration vessel must be filled with water to 20-
30 cm height in order to prevent possible damage of the vessel and bottom glass.
• Fill the filtration vessel chamber with sand fill using silica sand (not included in the
supply). The silica sand grain size must be 0,6–1,2 mm.
• Clean the filtration vessel with care. Seating face of sealing ring and its surface
must be clean, without any residues of impurities and sand. Slightly lubricate the-
se surfaces with grease. Check whether the sealing has been inserted correctly..
NOTE: The filtration vessel may not be overfilled with sand and the sand must not
enter the chamber for clean water, otherwise this sand might be washed out into
the pool. According to EN 12904 about 10% of lower size grain may be in the dec-
lared grain size. This may cause small amount of fine sand in the pool until the fine
grains are washed out from the filter.
EN
39