Filling The Pressure Sprayer Tank; Building Up The Operating Pressure; Spraying; Cleaning And Care - FLORABEST HG01665 Bedienungs- Und Sicherheitshinweise

Filling the pressure
sprayer tank (Fig. D)
Note: Before using the product, check to
see that it is in good condition and free of
defects.
P ress the pump handle
and turn it anticlockwise.
Note: Before you open the tank, pull
the safety valve
any residual pressure still present in the
container .
5
D raw the pump
.
5
N ow fill the tank.
Note: Fill the tank with only the
amount of liquid that you actually need
for that particular spraying session (not
more than 5 l).
P lace the pump
tainer and turn the pump handle
5
clockwise as far as it will go.
Building up the operating
pressure
M ove the pump handle
until the pressure sprayer has been
pumped up to a pressure not exceeding
the maximum permissible operating
pressure of 2.5 bar. To ensure this value
is not exceeded, monitor the pressure
gauge during the pumping process.
4
Note: If the pressure of the air in the
container exceeds 2.5 bar, the pres-
5
sure is automatically released through
the safety valve
P ress the pump handle
into the recesses.
N ow take the spray tube
holder.
downwards
1
upwards to release
3
out of the container
2
back into the con-
2
up and down
1
.
3
downwards
1
out of the
8

Spraying

H ang the pressure sprayer over your
shoulder by the carrying strap
Note: Ensure that the pressure sprayer
is always kept upright. Only when held
in this orientation will the sprayer work
properly.
H old the spray tube firmly by the han-
dle and direct the adjustable spray
11
nozzle
7
P ress the trigger
process.
R elease the trigger
spraying process.
Note: When the pressure in the con-
tainer is no longer sufficient to spray,
5
pump the container
pressure again up to but not exceeding
the maximum permissible operating
pressure of 2.5 bar. You can check the
1
operating pressure using the pressure
gauge
4
ing pressure").
P ull the safety valve
as it will go to release the residual pres-
sure in the container

Cleaning and care

I f the nozzle seems to be blocked, do
not try to blow it free with your mouth.
Note: Clean the pressure sprayer after
each use! Empty the bottle after each use.
e.g. at a plant.
to start the spraying
13
to stop the
13
to increase the
5
(see "Building up the operat-
upwards as far
3
.
5
GB/CY
.
6
9