Clean The Pressure Sprayer; Clean The Suction Hose; Store The Pressure Sprayer; Troubleshooting - FLORABEST HG01665 Bedienungs- Und Sicherheitshinweise

Clean the pressure
sprayer
U nscrew the spray nozzle
C lean the spray nozzle
water.
I f the spray nozzle
clean it by pushing a needle through it.
F lush through the pressure sprayer,
pipes and tubes with water.
C lean the surfaces of the product with
a moist cloth.

Clean the suction hose

Clean the suction hose
L oosen the union nut of the suction hose
on the container
9
P ull the suction hose
tank .
5
C lean the suction hose
water.
A fter cleaning, insert the suction hose
back in its opening on the tank
12
T ighten the union nut
Store the pressure
sprayer
R elease any residual pressure still present
in the container after use. To do this,
pull the safety valve button upwards
until you can no longer hear the hiss of
escaping air.
T horoughly clean the device and allow
it to dry before you put it away for the
winter. This will avoid frost damage.
C lean the pressure sprayer before storing
it away.
R emove any leftover spray product from
10 GB/CY
.
7
under running
7
is clogged,
7
as follows:
12
.
5
out of the
12
under running
12
.
5
hand-tight.
9
the tank and the pipes.
S tore the pressure sprayer in a dry,
dust-free place.

Troubleshooting

If the measures listed below are not success-
ful, contact the manufacturer.
= Fault
= Potential causes
= Remedies
No pressure is established in
the tank.
The pump is not firmly screwed into
place.
Screw the pump firmly into place.
The sealing ring of the pump has not
been greased.
Grease the sealing ring of the pump.
Spray nozzle does not spray.
No pressure present.
Generate pressure using the pump.
The spray nozzle is blocked.
Clean the spray nozzle.
No spray in the tank.
Fill with spray.
Filter is blocked.
Clean the filter.

Disposal

The packaging is made entirely
of recyclable materials, which
you may dispose of at local
recycling facilities.