Fagor FIS 820 Bedienungsanleitung Seite 14

After completed defrosting, turn the knob to desired position
and close the refrigerator door.
The cause of increased ice formation may be one of the
following:
− the door does not seal well (clean the gasket if it is
contaminated, or replace it if it is damaged);
− the door was frequently opened or it was left opened for
too long;
− the food stored in the refrigerator was warm;
− the food or dish is touching the inner back wall.
Sound alarm
The excessive dust upon the condenser is signaled by the
sound alarm, heard at each opening of the appliance door –
until the default is removed.
Check the air circulation through the bottom rail openings and
if necessary clean or vacuum the dust from the condenser.
See Section Cleaning and Maintenance.
Water drains into the bottom compartment of the
appliance
Water leaks from the refrigerator if the drain hole is clogged, or
if the water drips past the collection gutter.
• Clean the clogged outlet, for example with a plastic straw.
• Manually defrost the increased ice layer. See "Ice Formation
onthe Inner Rear Wall".
Noise
Cooling in refrigerating-freezing appliances is enabled by the
cooling system with compressor, which produces noise. How
noisy the appliance is depends on where it is placed, how it is
used and how old the appliance is.
• During the operation of the compressor the noise of liquid
is heard and when the compressor is not operating, the
refrigerant flow is heard. This is a normal condition and it
has no influence whatsoever on the lifetime of the appliance.
• After starting the appliance, the operation of the
compressor and the refrigerant flow may be louder, which
does not mean that something is wrong with the appliance
and it has no influence on the lifetime of the appliance.
Gradually the noise is reduced.
WE RESERVE THE RIGHT TO ALTER THE SPECIFICATIONS WITH NO INFLUENCE ON THE
14
• Sometimes unusual and stronger noise is heard, which is
rather unusual for the appliance. This noise is often a
consequence of inadequate placing.
Bulb Replacement
Before replacing the light bulb, disconnect the appliance form
the power supply.
Press the cover at the rear side (in the arrow 1 direction) and
remove the plastic cover (in the arrow 2 direction). Replace the
bulb with a new one (E14, max. 15 W).
Don't forget: the old bulb does not belong to organic waste.
Light bulb is consuming good therefore our in-guarantee
service does not relate to it.
OPERATION OF THE APPLIANCE.
Instructions for Use
− The appliance shall be placed and levelled firmly on
solid base.
− It should not touch the wall or kitchen units standing next
to it.
− Check the accesories in the interior of the appliance,
they should be placed correctly in their positions; also
check the bottles, tins and other vessels that might
touch each other and rattle.