Pair" With Your Bluetooth ® Mobile Phone; Making A Call; Ending A Call; Answering A Call - Jabra SP 500 Bedienungsanleitung

4
"Pair"² with your Bluetooth mobile phone
1. Ensure SP500 is switched on. (See section 3)
2. Press the Pairing button until you see a solid blue light (approximately 2 seconds),
then release. Your Speaker phone is now in pairing mode.
3. Set your Bluetooth phone to "discover" the speakerphone by following your
phone's instruction guide. Typically, the steps involve going to a "setup", "connect",
or "Bluetooth" menu on your phone and then selecting the option to "discover" a
Bluetooth device*. (See example from a typical mobile phone in fig. 3)
4. Your phone should find the "Jabra SP500" speakerphone and ask if you want to pair
with it. Confirm by pressing "yes" or "ok".
5. Enter passkey or PIN³ = 0000 (4 zeros), then press "yes" or "ok"
IMPORTANT: If pairing was successful, the blue indicator light will briefly flash rapidly
before going back to flashing blue every 3 seconds. You will also hear the confirmation
melody. If unsuccessful, the light remains solid, and you'll need to re-attempt pairing.
(See steps 3–5 above)
USING YOUR JABRA SP500
Before using your Jabra SP500, ensure that the batteries are charged and the Jabra SP500
is paired (see item 3) with your Bluetooth mobile phone and switched on.
The speakerphone can be used while being recharged from a wall socket or from the car
charger.
5

Making a call

Using your mobile phone's keypad
1. Dial number on keypad.
2. Press phone's "send" key.
3. The Jabra SP500 has automatic volume control and will automatically adjust the
speaker volume based on the relevant back ground noise. In order to adjust the
volume according to your own preferences, use the volume control wheel.
Using voice-dialling (if supported by your phone)
1. Press and release once. You'll hear one short beep while doing this.
2. You'll then hear the voice-activation tone; say the name of the person you wish to call.
NOTE: Record voice tag via your mobile phone. If you have a Nokia phone you will be
able to record the voice tags via your Speakerphone.
4
6

Ending a call

• Press and release once
OR
• End call from your mobile phone's keypad
7

Answering a call

• After you hear the ring tone, press and release
OR
• Answer the call with your mobile phone's keypad. You may then need to transfer the call
to the speakerphone by pressing and releasing
8

Muting a call

• To enable mute press the mute button for one second and you will hear a short
beep. You'll see solid yellow light.
To disable mute function press the mute button briefly.
9

Call-waiting*

• It is recommended that you use your mobile phone's keypad which typically
involves pressing the "send" button.
OR
• Press and hold until you hear two beeps to answer the incoming call and switch
between calls (some phones do not support call-waiting via this method).
* See Enhanced features section for alternative call-waiting instructions for
mobile phones that support the hands-free profile. See Section 13 for further
details about Bluetooth profiles.
10

Indicator light

To avoid the Jabra SP500's LED lights from distracting you when driving at night the LED
lights will be switched off 1 min after an active call. It is also possible to prevent the LED
from flashing by pressing and holding the mute button for 10 seconds until you hear a
second beep. The Jabra SP500 will still function during this time. When you switch off
the unit and then switch it back on again the LED lights will commence flashing again.
once.
once (depending on your phone).
5