Radio- Und Cd-Operation - auna multimedia 10027418 Handbuch

Turning Off the Alarm
To switch off an alarm while active, press the Standby button on the unit. The alarm will reset for next day.
Adjusting the Volume
• Press VOL+ button to increase the volume.
• Press VOL- button to decrease the volume.
Press the standby button to switch on the unit. Press the FUNTION button on the unit to the radio function. How
to use the buttons for radio:
• Manual Tuning: Press the
sing the button while lower frequency can be selected by pressing the
• Automatic Tuning: Press and holf the
sufficient strength has been found Tuning will stop or you can stop the automatic tuning by pressing
• To switch off the radio, Press the Standby button.
Preset Tuning
1 Select your desired station according to the normal tuning procedure.
2 Press the PROG button on the unit, "P-01" will appear and flash on the display, Then use M- or M+ button to
change the number where the station will be stored. (P01 to P20) to change the number where the station will
be stored. (P01 to P20)
3 Store the current frequency by pressing PROG button on the unit again when you get the desired number.
4 Repeat the same procedure to set other desired frequencies into Memory No.1 to No.20.
Memory Recall
Recall the stored frequencies by pressing M- or M+ button on the unit to select 1 to 20 stations as desired
NOTE: As stored frequencies can only be stored for long time with the power supplying. The station you stored
will be lost and can not be recalled in case that you cut off the power.
Handling a Compact Disc
• Always protect a disc against scratches, soil, dust and etc. If a disc is treated with reasonable care, wiping off the
disc with a soft cloth should be the only maintenance needed to retain its excellent sound reproduction. Discs
should be retained in their original case during periods of non-use.
• Handle a disc only by its edges, do not touch the surface or rainbow-colored side of the disc.
• Use a soft cloth to wipe a disc clean. Do not use benzene, thinner, or other chemical cleaners to clean the disc
as damage may result. A disc should always be wiped in a straight line from its center to its edge. Never wipe
a disc in a circular motion.
• Do not expose a disc to direct sunlight, high humidity, or high temperatures for extended periods of time. Do not
place the Disc on other equipment or near any heat source. Dust on the pickup lens can lead to erratic operation
and interruption of the sound during play. To clean the pickup lens, open the disc compartment and blow the
dust off. Using a camera lens blower (available at most camera stores)
• Note: Do not touch the surface of the lens. Do not allow any liquids on the inside of the product.
• To clean the CD player cabinet, use a soft and damp cloth to wire off the exterior surface.Never use benzol,
benzene, or other strong chemical cleaners, as these could damage the finish.
Radio Operation
or to search for desired frequency. Higher frequency can be selected by pres-
or button until the display frequency starts run. When a station of
CD Operation
button.
or .
15