Getting Started; Alarm And Volume - auna multimedia 10027418 Handbuch

Battery Backup
Two 1.5V "AAA" batteries (not included) may be installed as a backup option to maintain the time if electrical pow-
er fails. In the event of a power outage, the time will not appear on the clock LCD Display, however the clock will
continue to operate and the actual time will be maintained. The Clock LCD Display and other functions will resume
once electrical power is restored if used the backup battery. The backup battery should be replaced as needed;
Remove the battery if the clock is not used or stored for long periods of time.
Setting the Clock Time
1 Connect the AC power cord to a wall outlet. Make sure that it is in "Standby off" mode.
2 Press the PROG BUTTON, the HOUR will blink.
3 Press the or Button to set the DESIRED HOUR,
4 Then press the PROG BUTTON again, the MIN will blink.
5 Press the or Button to set DESIRED MINUTE.
6 Then press the PROG BUTTON again to choose 24/12 hours when it is set in 12 Hours will appears AM/PM to
identify AM or PM. Press the PROG BUTTON to confirm.
1 Press and hold the AL.SET button on the unit, the alarm1 icon and HOUR time will blink.
2 Then press the or
3 Press the AL.SET button on the unit or remote control, The MIN time will blink
4 Then press again
5 After setting the alarm time as your desired, to press AL.SET button again. You can now select whether the
alarm should go on to Buzzer, Radio or CD.
Wake to buzzer
This is the default setting (no indication on the display above the time).
Wake to Radio
Press the or button until "FM" is shown in the display(above the time). At the set time the alarm will go on
at the radio station you last listened to.
Wake to CD
Press the or button until the CD icon is shown in the display (above the time). This feature only works when
you have a CD inserted in the CD drive. This CD will be played at the set alarm time.
Wake to USB
Press the or button until the "USB" icon is shown in the display (above the time). This feature only works
when you have a USB disk inserted in the USB port. This USB will be played at the set alarm time.
6 Press the AL. SET button again to confirm your settings for Alarm 1.
7 The alarm icon (Alarm 2) appears and the HOUR time is blinking.
8 Repeat step 2-6 in order to set Alarm 2.
9 To select which of the 2 alarms should be active, press the AL. SET button repeatedly while the unit is in stand-
by mode (clock display). The display will show consecutively the Alarm 1 icon, the Alarm 2 icon, the both Alarm
icons. Press the AL. SET button once again to deactivate the alarms (no alarm icon will be displayed).
SNOOZE Function
If you want to snooze a few more minutes, press the STOP button on the unit, it will deactivate the sound for 9
minutes and will shown "SNOOZE" on the LCD Display. To turn off the snooze function, press the Standby button.

Getting Started

Alarm and Volume

button to set the Desire Hour
or to set the Desire Minute.
14