Jacuzzi J-300 Serie Vorinstallationsblatt Seite 16

It is the responsibility of the installer/owner to ascertain
compliance with specific local regulations prior to installa-
tion.
Jacuzzi Europe S.p.A. gives no guarantee in this respect and
refuses all responsibility regarding compliance of the instal-
lation carried out.
Technical Features
The Jacuzzi spas feature a single-phase power supply (220-240
V). All electro-mechanical parts and pipes are enclosed.
J-315/325/ hot tubs are equipped with 1 hydromassage pump
plus a recirculation pump.
J-335/345/355/365/375/385 hot tubs are equipped with 2 hydro-
massage pumps plus a recirculation pump.
Maximum absorption of the system
The electrical system that powers the spa must absolutely be
sized for maximum consumption (as shown in the table).
Power supply
(single-phase)
Volt
J-315 220-240 ~
J-325 220-240 ~
J-335 220-240 ~
J-345 220-240 ~
J-355 220-240 ~
J-365
220-240 ~
J-375
220-240 ~
J-385
220-240 ~
(k): a 230V (single-phase) / (j): max. power absorption
If sufficient electrical energy is not available, an electronic energy
consumption limiter can be activated from inside the electronics
box.
This operation can only be performed by authorized Jacuzzi®
technicians and limits electricity consumption as follows:
- J-315/J-325
Alternative consumption: 3.5kW/15A (by activating a pump, the
electric heater switches off).
- J-335/J-345/J-355/J-365/J-375/J-385
Alternative consumption: 3.9kW/17A (by activating a pump, the
electric heater switches off).
Tot. Consumption:
electric heater + pump(s)
Hertz Ampere
(k)
50 22
50 22 (k)
50 29 (k)
50 29 (k)
50 29 (k)
(k)
50 29
(k)
50 29
(k)
50 29
Weights
net weight
kg
J-315 ~ 259
J-325 ~ 312
J-335
~ 342
J-345
~ 374
J-355
~ 379
J-365
~ 394
J-375
~ 407
J-385
~ 415
User safety
The system, if installed by qualified personnel, does not pres-
ent any hazard for the user. Safety is however also contingent
upon proper use, as set forth by the user's manual included with
the product. The user must contact qualified personnel for spe-
cial operations described in the manual.
It is important to make sure that personnel tasked to install
kW
and manage the system are qualified as per legal requirements in
(j)
5,1
effect in the country where installation is carried out.
5,1 (j)
This appliance uses and generates radio waves: if it is not in-
6,7 (j)
stalled and used as directed, it may cause interference with the
6,7 (j)
reception of radio and television programs.
6,7 (j)
However, in special cases this may happen even if the directions
(j)
6,7
provided are followed.
(j)
6,7
(j)
6,7
Positioning the Jacuzzi remote monitoring
system
Check the power level of your domestic Wi-Fi router in the loca-
tion where you want to install the spa.
If the router's Wi-Fi signal is strong (3-4 bars) and internet access
is stable, it is an optimal location to install the spa. If it is weak, it
may be necessary to select another position or install a "repeater"
to make the signal stronger.
Refer to the relative user and maintenance manual.
Set up for installation
The site where the hot tub will be installed must be de-
signed to ensure the possible removal and relocation of
the hot tub itself, if necessary.
Position the hot tub away from glass and/or reflective
surfaces in order to avoid possible damage to its panel-
ling.
The customer must make provisions for a ground drainage
point ( 8) of suitable dimensions and that can be inspected for
any cleaning that may be required.
16
average fill max. water total
volume max. weight
litres litres kg
~ 871 ~ 1060 ~ 1319
~ 1363 ~ 1666 ~ 1978
~ 1363 ~ 1703 ~ 2045
~ 1401 ~ 1741 ~ 2115
~ 1514 ~ 1855 ~ 2234
~ 1666 ~ 1893 ~ 2287
~ 1779 ~ 2196 ~ 2603
~ 1893 ~ 2196 ~ 2611
support load concentrated
area on support area
m2 kg/m2
~ 2,37 ~ 556
~ 3,38 ~ 585
~ 3,41 ~ 599
~ 3,41 ~ 619
~ 3,64 ~ 613
~ 3,64 ~ 627
~ 4,05 ~ 642
~ 4,05 ~ 644