Troubleshooting - Cleco 936491PT Bedienungsanleitung

LED should not be flashing red before it is plugged in. The battery could be damaged.
Disconnect the charger from the power supply, wait about 1 minute and then reconnect.

When charging is finished, the charger automatically shuts off the charging process. LED
manently in green.
4

Troubleshooting

LED
Charger
2069b_1_5_en_bedingt.fm, 25.09.2015
LED
Battery Error
• No power supply voltage
• Power cable defective
• Charger defective
• Charger defective
• Battery defective
• No battery contact
• Contacts are dirty
• Battery defective
• Charger + battery defec-
tive
• Error charger:
Temperature too high
– Only 44 V –
• Error battery:
Temperature too high
– Only 44 V –
• Error communication
P2069BA/INT 2015-08
EN
Measure
Check and restore the power supply vol-

tage.
Replace power cable

Send charger to Sales & Service Center.

Send charger to Sales & Service Center.

Send battery to Sales & Service Center.

Insert battery again

Clean contacts of the charger and battery

Check battery and replace if necessary

Do not further operate the defective devices

(charger + battery).
Replace charger + battery for new devices.

Send defective charger + battery to Sales &

Service Center.
No action required

Charging is automatically started / continued
after cooling
No action required

Charging is automatically started / continued
after cooling
Insert battery again

Clean contacts of the charger and battery

Troubleshooting
4
lights up per-
23