Initial Operation; Troubleshooting - Cleco 936491PT Handbuch

3

Initial operation

3 Initial operation
WARNING!
Risk of explosion if other batteries are used
Use only to charge CLECO lithium ion batteries, order no. 936400PT or order no. 935377.

Never use to charge other battery types.
LED
Disconnect the charger from the power supply, wait about 1 minute and then reconnect.

When charging is finished, the charger automatically shuts off the charging process. LED
manently in green.
4

Troubleshooting

Fault
LED
functioning power supply
LED
is plugged in
LED
even though battery is plugged in
LED
LED
20
should not be flashing red before it is plugged in. The battery could be damaged.
does not light up despite
goes out when the battery
does not light up / flash
flashes red
lights up red
P2069BA/INT 2015-06
EN
Connecting the charger to the power network:

LED lights up green and indicates that
power is supplied.
Plug the battery into the charger and make

sure that it is securely connected.
LED
charging is in progress.
Cause
No power supply voltage
Power cable defective
Charger defective
Faulty charging electronics
No battery contact
Contacts are dirty
Battery is damaged
Battery is damaged
The temperature in the battery is
too high or < 0°C (32 °F)
is flashing green, indicating that
Measure
Check and restore the power

supply voltage
Replace power cable

Replace charger

Replace charger

Plug the battery in again

Clean the contacts of the char-

ger and battery
Check battery and replace if

necessary
Check battery and replace if

necessary
Remove battery from charger

and repeat charging after
approx. 10 min
2069b_1_5_en_bedingt.fm, 04.08.2015
lights up per-