Connection To The Mains - Tecfrigo Carrello Zusammenbau Und Betrieb

6. THE EXTRACTABLE TABLE
Hold the outer edge of the table and pull it out by 40 cm at the most. The table can be pulled out from
I
both sides of the
UK
7.

CONNECTION TO THE MAINS

1 . Ensure that mains voltage and frequency are the same as those stated on the rating plate (A) attached
D
to the appliance.
rated current as set out on the rating plate; c) complies with the IEC regulations:- thermal-magnetic switch
with In = rated value as stated on the rating plate; - differential with Id sensitivity = 30 mA. . Ensure that
E
there is no danger of explosion (AD) in the room. . Make sure the environment is suitable for the power
supply cable provided. The cable of the appliance is H05 VVF, designed for internal use. For installation
F
in other than internal settings, it will be necessary to replace the cable with the appropriate type (for
example H07 VVF for external settings). . Insert the plug in the socket (do not use three-way adapters
NL
and reduction adapters).
its correct position for at least 3 hours before hooking it up to the mains (see picture 6)
P
8.
OPERATIONS AND ADJUSTMENT
S
The controls are located inside a protected recess on one side of the appliance.
(1) Thermometer
DK
(2)Refrigeration switch:
3 "SET"
press key
FIN or key "5" DOWN
!
CAUTION:
Before placing goods ensure that:
B
1.
the plug is connected; . the refrigeration unit switch is turned on (green light lit up); . internal lights
GR
4.
are on; sliding panels and cover are closed; . thermometer shows the desired temperature for the
goods to be stored;
CZ
temperature does not exceed +30°C with 55% R.H. (climatic class 4).
the motor compartment. . cover is closed.
EE
LV
LT
H
M
PL
SK
SLO
Operator's guide
appliance (see picture 5).
2
. Ensure that the supply socket: a) is properly earthed; b) fulfils the requirements of the
5
N.B.:
if the equipment has been transported or stored overturned, let is rest in
for reading the temperature inside the appliance.
for turning on the refrigeration system.
once to display the temperature set-point, which can be changed by pressing key
(see picture 2)
2
6. appliance is not exposed to direct sunlight or to powerful lamps; . ambient
7
4
5
6.
6
3
3
7
there is sufficient ventilation for
"4" UP