Removing The Rechargeable Battery - Philips FC8796 Bedienungsanleitung

- This symbol means that this product contains a built-in rechargeable battery which shall not be
disposed of with normal household waste (Fig. 52) (2006/66/EC). Please take your product to an
official collection point or a Philips service center to have a professional remove the rechargeable
battery.
- Follow your country's rules for the separate collection of electrical and electronic products and
rechargeable batteries. Correct disposal helps prevent negative consequences for the environment
and human health.

Removing the rechargeable battery

Only remove the rechargeable battery when you discard the product. Before you remove
the battery, make sure that the product is disconnected from the wall socket and that
the battery is completely empty.
Take any necessary safety precautions when you handle tools to open the product and
when you dispose of the rechargeable battery.
Removing the rechargeable battery
Warning: Only remove the rechargeable battery when you discard the appliance. Make
sure the battery is completely empty when you remove it.
To remove the rechargeable battery, follow the instructions below. You can also take the robot to a
Philips service center to have the rechargeable battery removed. Contact the Philips Consumer Care
Center in your country for the address of a service center near you.
1 Let the robot run until the rechargeable battery is empty to make sure that the rechargeable
battery is completely discharged before you remove it and dispose of it.
2 Undo the screws of the battery compartment lid and remove the lid (Fig. 53).
3 Lift out the rechargeable battery and disconnect it (Fig. 54).
4 Take the robot and the rechargeable battery to a collection point for electrical and electronic
waste.
Troubleshooting
This chapter summarizes the most common problems you could encounter with the appliance. If you
are unable to solve the problem with the information below, visit www.philips.com/support for a list
of frequently asked questions or contact the Consumer Care Center in your country.
Problem
The robot does not start
cleaning when I press the
start/stop button.
The robot does not
respond when I press
one of the buttons.
The robot beeped and
stopped.
Possible cause
The rechargeable battery is
empty.
The robot could not find the
docking station and the
battery ran out.
One or both wheels are stuck.
Solution
Charge the rechargeable battery (see
'Preparing for use').
Place the robot on the plugged-in
docking station. After a few seconds, the
robot beeps and the display lights up.
Press the start/stop button. Remove the
fluff, hair, thread or wire that is caught
around the wheel suspension.
English
13