Inhaltsverzeichnis
Werbung
English
LUBRICATION
● This tool is fitted with blades which
can operate without lubricated air.
However, a small amount of oil allows
the tool to provide full power and
lengthens its life.The use of dry air
with no trace of oil may reduce the life
of blades.
● After cleaning or changing the rotor or
the vanes, introduce 5 drops of oil into
the motor for the complete lubrication
of the mechanical parts.
● For a good durability of the collet,
we recommend to lubricate the collet
cone frequently.
MAINTENANCE INSTRUCTIONS
The use of spare parts other than those
originally supplied by the manufacturer
may result in a drop in performance or
in increased maintenance and level of
vibration and in the full cancellation of the
manufacturer's liability.
To obtain maximum efficiency from the
pneumatic tool, preserve its features
and avoid repeated repairs, a routine
inspection and repair programme are
recommended at least every 1000
hours, the intervals between the various
inspections depending on the amount of
exertion on the power tool.
When disposing of components,
lubricants, etc... ensure that the relevant
safety procedures are carried out.
The rotor blades in this tool have a PTFE
content. The normal health and safety
recommendations concerning PTFE must
be observed when handling these rotor
blades.
● Do not smoke.
● Motor components must be washed
with cleaning fluid and not blown clear
with an air line.
● The silencer must be replaced when
dirty, do not clean and re-use.
● Wash hands before commencing any
other activity.
08/2015
DISASSEMBLy AND REASSEMBLy
INSTRUCTIONS
See page 4.
Disconnect the machine from the
compressed air supply.
Remove all accessories.
Disassembling the tool
● For each maintenance, O-rings must be
replaced and greased.
● Remove the exhaust kit (50) from the machine
and unscrew the inlet hose (56) holding the
19mm flat on the machine (drawing 2).
● Remove the silencer sintered bronze (55).
● Place the Housing tool kit (65) in a vice and
insert the machine in the two pins for holding
it.
● Unscrew the Throttle kit (1) with a 19mm
spanner (drawing 3).
● By using standard a chuck, all internal parts or
assemblies can be removed.
Assembling the tool
● Take the rotor body assembly (3) and insert
blades (19) in the rotor (18) taking care of the
side (drawing 4).
Be careful with the direction for
assembling the blades.
● Place the cylinder (17) around the rotor taking
care of the side (drawing 5) and then the back
plate kit (2).
● Insert the overall in the housing.
● Screw and tighten the throttle kit (1) with a
torque between 6 to 8 N.m using the same
method as the disassembly (drawing 2).
● Insert the silencer sintered bronze (55).
● Tighten the mounted inlet hose (56) with a
torque between 6 to 8 N.m. and then place
the exhaust kit (50) (drawing 2).
Maintenance of throttle kit & rotor body
assembly
For theses assemblies, specials toolings or
instructions are necessary.
● Tooling kit (6153964180) or Complete
service kit (615396419 0) are needed for this
operation.
9 / 36
6159947510_07
Indicates direction of dismantling.
Series: C
Werbung
Inhaltsverzeichnis
