Troubleshooting - Concept EP2920 Bedienungsanleitung

EN
Removable drip tray
Check the cleanliness and amount of water in the drip tray regularly. The tray and grate should be washed in warm water
and wiped dry.
Coffee filter holder, coffee filter, and filter head
The filter and coffee filter holder should be washed in warm water with detergent after each use. A clogged coffee filter
may be cleaned using a fine brush. The filter head should be cleaned by turning the unit on without coffee and wiping
it with a wet cloth.
Steam nozzle
Clean the nozzle after each frothing. Dip it into a cup of warm water, open the steam valve for about 30 seconds, and
wipe it with a wet cloth. Remove the steam nozzle cover and rinse it in lukewarm water.

TROUBLESHOOTING

Problem
The unit does not turn on after moving the
mode selector from the "O" position.
The espresso or coffee is not sufficiently
hot.
Coffee flows out too slowly.
Coffee does not flow out of the proper
openings.
Steam is not released from the nozzle.
There is insufficient milk froth available.
The unit does not draw water after filling
the water tank.
There is water or coffee under the unit.
REPAIRS & MAINTENANCE
Any extensive maintenance or repair requiring access to the inner parts of the product must be performed by an expert
service centre.
EP2920
Make sure the power cord is plugged into the wall outlet properly.
Warm the cups by rinsing in hot water.
Reduce the amount of coffee in the filter.
Discharge opening is clogged with dried coffee. Unclog the opening
using a pin.
Unclog the steam discharge opening with a needle.
Make sure the nozzle is letting steam through. If needed, clean the
small air supply opening in the top section of the nozzle. The milk and
bowl should be cold (recommended temperature 5 – 8 °C). Change
the milk type, if necessary (whole milk or cream).
Make sure the tank is installed properly.
The drip tray has overflowed. Empty the tray. Make sure the drip tray is
installed properly.
Solution
29