Magnescale SR84 Bedienungsanleitung Seite 4

Slider installation procedure
Th e slider can be mounted using one of the four methods
below.
Pattern 1
Pattern 2
Pattern 3
Installing the rubber bushing on the M4 nut enables
installation without the nut falling off .
Note
Because the nut position is limited by the rubber bushing,
pay careful attention to the tolerance of the slider mounting
holes.
Pattern 4
Th e M6 hex. socket-head cap screws must be supplied by
the customer.
4
(E)
M4 tap M4 tap
M4 nut M4 nut
(opposite side: 8 mm) (opposite side: 8 mm)
Rubber bushing Rubber bushing
M4 nut M4 nut
(opposite side: 7 mm) (opposite side: 7 mm)
M6 tap M6 tap
M4 × 20 M4 × 20
M4 × 20 M4 × 20
M4 × 20 M4 × 20
M6 M6