Troubleshooting; Ec Declaration Of Conformity - Lelit PS25SP Bedienungsanleitung

TROUBLE SHOOTING:
PROBLEM
It may happen that, while filling
1) little steam the tank, some water spills over
comes out from the the cap and flows inside the
boiler boiler
material
2) The steam brush While filling the tank you may
leaks steam mixed have poured too much water into
with water it.
The iron switch might be off
3) The brush does
The boiler switch might be off
not produce steam
The water might be used up (the
low water light indicator might be
on)
The ironing board cover might
not be able to absorb the steam
completely
4) The ironing
board gets wet The steam brush leaks steam
mixed
spraying some steam on a dry
cloth)
5) The iron leaks Maybe some dirty water might
dirty water have gone into the tank.
The inserted data and pictures can be subject to changes without previous notice for the improvement of the
machine's performances.
EXPLANATION
wetting the insulating
with water (check
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN
ACCORDANCE WITH EC DIRECTIVE 2002/96/EC
At the end of its working life, the product must not be disposed of as urban waste. It
must be taken to a special local authority differential waste collection centre or to a
dealer providing this service. Disposing of a household appliance separately avoids
possible negative consequences for the environment and health deriving from
inappropriate disposal of enables the constituent materials to be recovered to obtain
significant savings in energy and resources.
household appliances separately, the products is marked with a crossed-out wheeled
dustbin.

EC DECLARATION OF CONFORMITY

Gemme Italian Producers srl declares under its own responsibility that the product
PS25SP, to which this declaration relates, is in accordance with the provisions of the
specific directives:
CEI EN 60335-1 / CEI EN 60335-2-3
It also declares that the above mentioned products conform with the electromagnetic
compatibility test EMC.
NB: The present declaration voids, should the machines be modified without our specific
authorization.
In order to solve the problem, we suggest using the
machine as usual so to dry up the insulating material
through the heat of the machine. In case you still
have this problem after one working hour, please
contact the service shop
Empty the machine from the water in excess (follow
the instructions regarding the opening of the safety
cap, before doing it)
Switch it on, the red led comes on.
Switch it on, the red led comes on: wait for 10
minutes so the boiler produces steam.
Fill it to the required level following the instructions
carefully.
You might use a thicker cover (or two covers) so to
create a thicker surface to absorb the steam better. In
case you are using a vacuum table, switch on the
vacuum function each time you are using the steam
by See # 2 (the steam brush leaks steam mixed with
water)
Fill the empty tank with 1 liter of water, screw the cap
up, shake it, open the cap and empty the tank.
Repeat the operation until the water is clean. We do
not recommend the use of any additive to pour in the
tank. Before using the steam brush again spray some
steam on a cloth until clean steam comes out.
As a reminder of the need to dispose of
Castegnato, 04/02/2013
Amministratore Delegato
ENGLISH
SOLUTION
Pag. 5