Troubleshooting - Lelit PG036 Handbuch

PG036
TROUBLE SHOOTING:
PROBLEM
It may happen that, while filling the
Does steam go out tank, some water spills over the
from the boiler? cap and flows inside the boiler
wetting the insulating material
While filling the tank you may have
Does the steam iron
poured too much water into it.
leak steam mixed
with water?
The iron plate has to be hot before
the steam passage
The iron button might be off
Does not the iron
The boiler button might be off
give off steam?
The water might be used up (the
low water light indicator might be
on)
The ironing board cover might not
be
completely
Does the ironing
board wet?
The steam iron leaks steam mixed
with water (check by spraying some
steam on a dry cloth)
Maybe there is some dirty water
Does the iron leak
might have gone into the tank and
dirty water?
it is given off from the iron.
The inserted data and pictures can be subject to changes without previous notice for the improvement of the
machine's performances.
EXPLANATION
able to absorb the
In order to solve the problem, we suggest using the
machine as usual so to dry up the insulating material
through the heat of the machine. In case you still have
this problem after one working hour, please contact the
service shop
The problem will go on until the excess water is emptied.
Keep the steam button depressed until the water in the
tank is at the correct level.
Please check that the temperature knob is on the right
position: "cotton °°°)"
Push the iron button the red le comes on; wait for 4
minutes so that the iron plate warms
Push the boiler button the red led comes on: wait for 10
minutes so the boiler produces steam.
Fill it to the required level following the instructions
carefully.
You might use a thicker cover (or two covers) so to
create a thicker surface to absorb the steam better. In
steam
case you are using a vacuum table, switch on the
vacuum function each time you are using the steam
See # 2
Fill the empty tank with 1 liter of water, screw the cap
up, shake it, open the cap and empty the tank. Repeat
the action until the water is cleaned. We do not
recommend the use of any additive to pour in the tank.
Before ironing again spray some steam on a cloth until
clean steam comes out.
SOLUTION
English
Pag. 5