Herunterladen Inhalt Inhalt Diese Seite drucken

Packing Content; Safety Instructions - Klarstein 10027905 Bedienungsanleitung

Zerkleinerer und entsafter
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Dear Customer,
Congratulations on purchasing this equipment. Please read this manual carefully and take care of the following
hints to avoid damages. Any failure caused by ignoring the mentioned items and cautions mentioned in the
instruction manual are not covered by our warranty and any liability.
1 x Processor bowl 0,5 litres
1 x Processor bowl cover with pusher
3 x Cutting plates
1 x S-Blade
1 x Juicer sueezer
1 x Juicer sieve
1 x Instruction manual
• Read all the safety and operating instructions carefully and retain them for future reference.
• The cutting plates are sharp, handle with care. Hold the knife blade by the finger grip at the top away from
the cutting edge, both in use and when cleaning.
• Keep hands and utensils out of the bowl whilst the mixer is connected to the power supply. Never use your
fingers to push food down the feed tube. Always use the pusher.
• Switch off and unplug: Before fitting or removing parts, after use, before cleaning.
• Always remove the cutting plate before pouring contents from the bowl.
• Never remove the lid from the attachment until the cutting plate has completely stopped.
• When slicing/shredding or chipping, don't let the bowl fill up as far as the cutting plate: empty it regularly.
• Should excessive vibration occur when using this attachment, either reduces the speed or stop the machine
and remove the contents.
• Never use a damaged attachment. Get it checked or repaired.
• Do not let children use or play with this attachment.
• Only use the appliance for its intended domestic use. It will not accept any liability if the attachment is sub-
ject to improper use, or failure to comply with these instructions. Use fresh ingredients
• Don't cut food up too small. Fill the width of the large feed tube fairly full. This prevents the food from slip-
ping sideways during processing. Alternatively, use the small feed tube.
• When using a chipper plate, place thin ingredients horizontally.
• When slicing or shredding: food placed upright comes out shorter than food placed horizontally.
• After using a cutting plate there will always be a small amount of waste on the plate or in the food.
• Don't blend liquid ingredients as they may leak from around the cover.
• Cut food up before placing into the bowl. Meat, bread, vegetables and other foods of a similar texture should
be cut into cubes approximately 2cm/3 4 in. Biscuits should be broken into pieces and added down the feed
tube whilst the machine is operating. If you want to blend soups, drain the ingredients and add the solids to
the bowl. Process and then add back to the liquid.
• 1 min ON + 2 mins OFF in a cycle, continuing to work 5 cycles, stop 40 mins.
• Capability of bowl: Max 350g (Meat MAX: 300g).
13

Packing Content

Safety Instructions

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis